Thermochemical and mechanistic studies of electrocatalytic hydrogen production by cobalt complexes containing pendant...

Two cobalt(tetraphosphine) complexes [Co(P(nC-PPh2)2N(Ph)2)(CH3CN)](BF4)2 with a tetradentate phosphine ligand (P(nC-PPh2)2N(Ph)2 = 1,5-diphenyl-3,7-bis((diphenylphosphino)alkyl)-1,5-diaza-3,7-diphosphacyclooctane; alkyl = (CH2)2, n = 2 (L2); (CH2)3, n = 3 (L3)) have been studied for electrocatalytic hydrogen production using 1:1 [(DMF)H](+):DMF. A turnover frequency (TOF) of 980 s(-1) with an overpotential at Ecat/2 of 1210 mV was measured for [Co(II)(L2)(CH3CN)](2+), and a TOF of 980 s(-1) with an overpotential at Ecat/2 of 930 mV was measured for [Co(II)(L3)(CH3CN)](2+). Addition of water increases the TOF of [Co(II)(L2)(CH3CN)](2+) to 18,000 s(-1). The catalytic wave for each of these complexes occurs at the reduction potential of the corresponding HCo(III) complex. Comprehensive thermochemical studies of [Co(II)(L2)(CH3CN)](2+) and [Co(II)(L3)(CH3CN)](2+) and species derived from them by addition/removal of protons/electrons were carried out using values measured experimentally and calculated using density functional theory (DFT). Notably, HCo(I)(L2) and HCo(I)(L3) were found to be remarkably strong hydride donors, with HCo(I)(L2) being a better hydride donor than BH4(-). Mechanistic studies of these catalysts reveal that H2 formation can occur by protonation of a HCo(II) intermediate, and that the pendant amines of these complexes facilitate proton delivery to the cobalt center. The rate-limiting step for catalysis is a net intramolecular isomerization of the protonated pendant amine from the nonproductive exoisomer to the productive endo isomer.