Correlation between the length and sagittal projection of the upper and lower jaw and the fundamental frequency
Anthony T Macari1, Ingrid A Karam1, Dollen Tabri2
1Division of Orthodontics and Dentofacial Orthopedics, Department of Otolaryngology - Head and Neck Surgery, American University of Beirut Medical Center, Beirut, Lebanon.
Objective:
To report on the correlation between the length and projection of the upper and lower jaw and the fundamental frequency (F0).
Study Design:
Prospective study.
Materials And Methods:
A total of 45 healthy subjects were included in this study. The facial skeletal measurements included: SNA, SNB, ANB, angles that reflect the position of the maxilla and mandible in relation to the base of skull and to each others, length of mandible Co-Gn, and length of maxilla PNS-ANS. All subjects underwent acoustic analysis using VISI-PITCH IV.
Results:
The means for F0 and habitual frequency were 220.75 + 40.01 Hz and 216.99 + 43.9 Hz, respectively. The means for SNA, SNB, and ANB were 80.753 ± 3.20, 77.409 ± 3.64, and 3.336 ± 2.57, respectively. The mean length of the mandible and maxilla were 104.28 + 7.94 and 50.29 + 3.94, respectively. In the total group, there was a moderate negative correlation between F0 and habitual frequency and the length of the mandible (r = -0.528 and -0.577, respectively). There was also a moderate negative correlation between F0 and habitual frequency and the length of the maxilla (r = -0.473 and -0.519, respectively). Similar findings were present after excluding the pubertal subjects. With respect to the other cephalometric measurements, the correlation was poor (r value < 0.3).
Conclusions:
There is a moderate negative correlation between the length of the upper and lower jaw and the average F0 and habitual frequency. The remaining facial sagittal projection parameters do not correlate with the average F0 and habitual frequency.
Related Concept Videos
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:08Determination of Expected Frequency
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:19Concept of Resonance and its Characteristics
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...