Comparative evaluation of the efficiency of four ceramic finishing systems

To compare the effect of four different finishing systems and diamond paste on ceramic roughness with the objectives of evaluating the roughness of ceramic surface of prepared specimens after abrasion, finishing and polishing.

A total of 50 test specimens were fabricated in the form of discs of diameter 13mm and 0.6mm thickness. Test specimens were then randomly distributed into five groups of 10 and coded. All the test specimens were then abraded with 125μm diamond in unidirectional motion to create surface roughness that will simulate occlusal or incisal correction. The values were recorded and the specimens were then finished using the various finishing systems. multiple range tests by Duncan's procedure. One way Anova was used to calculate the p-value Results:After fini shing, the Ra,Rq,Rz and Rt values showed a tendency to decline to levels much inferior to the values obtained after the preparation of the specimens. Ra values of group III specimens were slightly higher and the increase was significant. The highest Rt value [5.29] obtained after polishing is below the lowest roughness values [7.42] obtained after finishing the specimens.

Finishing and polishing procedures have a significant role in reducing the roughness of ceramics.Following abrasion with diamond point to simulate clinical adjustment the roughness values doubled when compared to the initial reading.Ra, Rq,Rz and Rt values suggest that Sof lex is the most efficient of all the systems tested followed by auto glazing.After the final diamond paste polishing, sof lex group specimens showed the best finish and auto glazed specimens showed a value almost as equal to the so flex group. How to cite this article: Aravind P, Razak PA, Francis PG, Issac JK, Shanoj RP, Sasikumar TP. Comparative Evaluation of the Efficiency of Four Ceramics Finishing Systems. J Int Oral Health 2013; 5(5):59-64.