Related Experiment Video

Updated: May 3, 2026

Systematic Hearing Performance Evaluation Process for Adolescents with Cochlear Implantation at Early Ages
06:04

Systematic Hearing Performance Evaluation Process for Adolescents with Cochlear Implantation at Early Ages

Published on: March 24, 2023

3.0K

Contribution of low-frequency harmonics to Mandarin Chinese tone identification in quiet and six-talker babble

Chang Liu1, Behnam Azimi2, Moulesh Bhandary2

  • 1Department of Communication Sciences and Disorders, University of Texas at Austin, 1 University Station A1100, Austin, Texas 78712.

The Journal of the Acoustical Society of America
|January 21, 2014
PubMed

More Related Videos

Author Spotlight: Investigating the Impact of Emotional Prosodies on Voice Recognition and Perception05:48

Author Spotlight: Investigating the Impact of Emotional Prosodies on Voice Recognition and Perception

Published on: August 9, 2024

1.8K
Machine Learning-Based Cough Tone Classification: Diagnostic Exploration of Chronic Obstructive Pulmonary Disease and Respiratory Tract Infections06:22

Machine Learning-Based Cough Tone Classification: Diagnostic Exploration of Chronic Obstructive Pulmonary Disease and Respiratory Tract Infections

Published on: September 19, 2025

751

Related Concept Videos

IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single...
2.0K
Modes of Standing Waves - I01:03

Modes of Standing Waves - I

A close look at earthquakes provides evidence for the conditions appropriate for resonance, standing waves, and constructive and destructive interference. A building may vibrate for several seconds with a driving frequency matching the building's natural frequency of vibration; this produces a resonance that results in one building collapsing while the neighboring buildings do not. Often, buildings of a certain height are devastated, while other taller buildings remain intact. This...
3.3K
Harmonic Mean01:09

Harmonic Mean

The arithmetic mean is usually skewed towards the larger values in the data set. Therefore, to avoid this inherent bias towards smaller values, the harmonic mean is used.
Take the example of the speed of a car, which is the measure of the rate of distance traveled. If the vehicle traverses the same distance back-and-forth, its average speed equals the total distance traveled divided by the total time taken. However, if the car moves with varying speeds, then the arithmetic mean is more skewed...
5.2K
¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
1.3K
Perception of Sound Waves01:01

Perception of Sound Waves

The human ear is not equally sensitive to all frequencies in the audible range. It may perceive sound waves with the same pressure but different frequencies as having different loudness. Moreover, the perception of sound waves depends on the health of an individual's ears, which decays with age. The health of one's ears may also be affected by regular exposure to loud noises.
The pitch of a sound depends on the frequency and the pressure amplitude of the source. Two sounds of the same...
4.7K
Concept of Resonance and its Characteristics01:19

Concept of Resonance and its Characteristics

If a driven oscillator needs to resonate at a specific frequency, then very light damping is required. An example of light damping includes playing piano strings and many other musical instruments. Conversely, to achieve small-amplitude oscillations as in a car's suspension system, heavy damping is required. Heavy damping reduces the amplitude, but the tradeoff is that the system responds at more frequencies. Speed bumps and gravel roads prove that even a car's suspension system is not...
5.4K