Evidence evaluation: measure Z corresponds to human utility judgments better than measure L and

Patrice Rusconi1, Marco Marelli2, Marco D'Addario3

  • 1School of Psychology, University of Surrey.

Related Concept Videos

Choosing Between z and t Distribution01:25

Choosing Between z and t Distribution

The z and the Student t distribution estimate the population mean using the sample mean and standard deviation. However, to decide which distribution to use for a calculation, one needs to determine the sample size, the nature of the distribution, and whether the population standard deviation is known. If the population standard deviation is known and the population is normally distributed, or if the sample size is greater than 30, the z distribution is preferred. The Student t distribution is...
2.9K
Introduction to z Scores01:05

Introduction to z Scores

A z score (or standardized value) is measured in units of the standard deviation. It indicates how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a zero z score. It is important to note that the mean of the z scores is zero, and the standard deviation is one.
z scores...
1.5K
Introduction to z Scores01:06

Introduction to z Scores

A z score (or standardized value) is measured in units of the standard deviation. It tells you how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a zero z score. It is important to note that the mean of the z scores is zero, and the standard deviation is one.
z scores...
8.4K
Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs01:15

Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs

Bioequivalence experimental study designs play a pivotal role in testing the effectiveness of various treatments. Key among these are the repeated measures, cross-over, carry-over, and Latin square designs. In the repeated measures design, each subject receives all treatments, allowing for temporal comparisons. This type of design is useful in reducing variability but requires careful planning to avoid bias.The cross-over design, an economical method, involves sequential administration of...
419
z Scores and Unusual Values01:07

z Scores and Unusual Values

The z score is one of the three measures of relative standing. It describes the location of a value in a dataset relative to the mean. z scores are obtained after the standardization of the values in a dataset. The z score for the mean is 0.
 This score indicates how far a value is from the mean in terms of standard deviation. For example, if a data value has a z score of +1, the researcher can infer that the particular data value is one standard deviation above the mean. If another data...
8.1K
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and...
659