Three comments on Teller's "bridge locus"

J Anthony Movshon1

  • 1Center for Neural Science, New York University, New York, New York.

Visual Neuroscience
|January 31, 2014
PubMed

Related Concept Videos

Properties of the Root Locus01:05

Properties of the Root Locus

The root locus method is an invaluable tool for analyzing higher-order systems without needing to factor the denominator of the transfer function. A pole of the system is identified when the characteristic polynomial in the transfer function's denominator equals zero.
To determine if a point lies on the root locus, the criterion involves the sum of angles contributed by all poles and zeros to that point. Specifically, this sum must be an odd multiple of 180 degrees. The gain at any point on...
392
Root Loci for Positive-Feedback Systems01:23

Root Loci for Positive-Feedback Systems

The Hartley oscillator is a positive feedback system that sustains oscillations by feeding the output back to the input in phase, thereby reinforcing the signal. Positive feedback systems can be viewed as negative feedback systems with inverted feedback signals. In these systems, the root locus encompasses all points on the s-plane where the angle of the system transfer function equals 360 degrees.
The construction rules for the root locus in positive feedback systems are similar to those in...
471
Construction of Root Locus01:15

Construction of Root Locus

The construction of a root locus involves several key steps to analyze and visualize the behavior of a system's poles with varying gain. The number of branches in the root locus equals the number of closed-loop poles and is symmetrical about the real axis.
For positive gain values, the root locus exists on the real axis to the left of an odd number of finite open-loop poles or zeros. The root locus starts at the open-loop poles and traces the paths of the closed-loop poles as the gain...
548
Design Example: Strain Gauge Bridge or Wheatstone Bridge01:15

Design Example: Strain Gauge Bridge or Wheatstone Bridge

The utilization of strain gauges as transducers for converting mechanical strain into electrical signals is a common practice in various engineering applications. These strain gauges are frequently integrated into Wheatstone bridge circuits to accurately measure parameters such as force or pressure. Within this context, each element within the circuit exhibits a resistance that undergoes subtle variations when subjected to mechanical strain. The primary objective is to convert minuscule...
1.3K
Wheatstone Bridge01:29

Wheatstone Bridge

An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
Thus, for accurate resistance measurements, a...
3.0K
Rotter's Locus of Control01:14

Rotter's Locus of Control

Julian Rotter introduced the concept of locus of control, a cognitive factor that significantly influences personality development and learning. Locus of control refers to an individual's beliefs about the extent of control they have over events in their lives. According to Rotter, this belief system can be categorized into two types: internal and external locus of control.
Individuals with an internal locus of control believe that their personal efforts and decisions directly affect their...
1.4K