Analytical calculation of four-point correlations for a simple model of cages involving numerous particles

Ooshida Takeshi1, Susumu Goto2, Takeshi Matsumoto3

  • 1Department of Mechanical and Aerospace Engineering, Tottori University, Tottori 680-8552, Japan.

Related Concept Videos

Correlation of Experimental Data01:23

Correlation of Experimental Data

Dimensional analysis simplifies complex physical problems and guides experimental investigations, but it does not provide complete solutions. It identifies the dimensionless groups that influence a phenomenon, but experimental data is needed to establish the specific relationships and validate theoretical predictions.
For example, a spherical particle moving through a viscous fluid experiences drag. Dimensional analysis shows that the drag force depends on the particle's diameter, velocity,...
603
Calculating and Interpreting the Linear Correlation Coefficient01:11

Calculating and Interpreting the Linear Correlation Coefficient

The correlation coefficient, r, developed by Karl Pearson in the early 1900s, is numerical and provides a measure of strength and direction of the linear association between the independent variable, x, and the dependent variable, y. Hence, it is also known as the Pearson product-moment correlation coefficient. It can be calculated using the following equation:
6.5K
One-Compartment Open Model: Wagner-Nelson and Loo Riegelman Method for ka Estimation01:24

One-Compartment Open Model: Wagner-Nelson and Loo Riegelman Method for ka Estimation

This lesson introduces two critical methods in pharmacokinetics, the Wagner-Nelson and Loo-Riegelman methods, used for estimating the absorption rate constant (ka) for drugs administered via non-intravenous routes. The Wagner-Nelson method relates ka to the plasma concentration derived from the slope of a semilog percent unabsorbed time plot. However, it is limited to drugs with one-compartment kinetics and can be impacted by factors like gastrointestinal motility or enzymatic degradation.
On...
1.5K
Equilibrium Conditions for a Particle01:23

Equilibrium Conditions for a Particle

When an object is in equilibrium, it is either at rest or moving with a constant velocity. There are two types of equilibrium: static and dynamic. Static equilibrium occurs when an object is at rest, while dynamic equilibrium occurs when an object is moving with a constant velocity. In both cases, there must be a balance of forces acting on the object.
To understand the concept of equilibrium, let us first consider the forces acting on an object. When different forces act on an object, they can...
2.4K
First Law: Particles in Two-dimensional Equilibrium01:18

First Law: Particles in Two-dimensional Equilibrium

Recall that a particle in equilibrium is one for which the external forces are balanced. Static equilibrium involves objects at rest, and dynamic equilibrium involves objects in motion without acceleration; but it is important to remember that these conditions are relative. For instance, an object may be at rest when viewed from one frame of reference, but that same object would appear to be in motion when viewed by someone moving at a constant velocity.
Newton's first law tells us about...
14.3K
First Law: Particles in One-dimensional Equilibrium01:10

First Law: Particles in One-dimensional Equilibrium

Newton's first law of motion states that a body at rest remains at rest, or if in motion, remains in motion at constant velocity, unless acted on by a net external force. It also states that there must be a cause for any change in velocity (a change in either magnitude or direction) to occur. This cause is a net external force. For example, consider what happens to an object sliding along a rough horizontal surface. The object quickly grinds to a halt, due to the net force of friction. If...
6.9K