Related Experiment Video

Updated: May 1, 2026

Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source
12:19

Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source

Published on: April 4, 2017

7.9K

Simulating of the measurement-device independent quantum key distribution with phase randomized general sources

Qin Wang1, Xiang-Bin Wang2

  • 1Institute of Signal Processing and Transmission, Nanjing University of Posts and Telecommunications, Nanjing 210003, China.

Scientific Reports
|April 15, 2014
PubMed

More Related Videos

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators09:23

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators

Published on: May 30, 2014

13.9K
A Photonic System for Generating Unconditional Polarization-Entangled Photons Based on Multiple Quantum Interference07:56

A Photonic System for Generating Unconditional Polarization-Entangled Photons Based on Multiple Quantum Interference

Published on: September 5, 2019

9.8K

Related Concept Videos

Propagation of Uncertainty from Random Error00:59

Propagation of Uncertainty from Random Error

An experiment often consists of more than a single step. In this case, measurements at each step give rise to uncertainty. Because the measurements occur in successive steps, the uncertainty in one step necessarily contributes to that in the subsequent step. As we perform statistical analysis on these types of experiments, we must learn to account for the propagation of uncertainty from one step to the next. The propagation of uncertainty depends on the type of arithmetic operation performed on...
1.9K
Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this...
1.4K
Conservative Site-specific Recombination and Phase Variation02:53

Conservative Site-specific Recombination and Phase Variation

Because the DNA segments are cut and reorganized in a direction-specific manner, site-specific recombination has emerged as an efficient genetic engineering technique. Flippase and Cyclization recombinases or Flp and Cre, respectively, are two members of the tyrosine recombinase family derived from bacteriophages, that are used to mediate site-specific DNA insertions, deletions, and targeted expression of proteins in mammalian cell lines.
The recognition sites for Cre recombinase called LoxP...
5.7K
Random Sampling Method01:09

Random Sampling Method

Sampling is a technique to select a portion (or subset) of the larger population and study that portion (the sample) to gain information about the population. Data are the result of sampling from a population. The sampling method ensures that samples are drawn without bias and accurately represent the population. Because measuring the entire population in a study is not practical, researchers use samples to represent the population of interest. Among the various sampling methods used by...
11.8K
Randomized Experiments01:13

Randomized Experiments

The randomization process involves assigning study participants randomly to experimental or control groups based on their probability of being equally assigned. Randomization is meant to eliminate selection bias and balance known and unknown confounding factors so that the control group is similar to the treatment group as much as possible. A computer program and a random number generator can be used to assign participants to groups in a way that minimizes bias.
Simple randomization
Simple...
6.3K
The Phase Rule01:20

The Phase Rule

The phase rule describes the relationship between the variance (degrees of freedom), the number of components, and the number of phases in a system at equilibrium.Variance is a concept that denotes the number of independent intensive properties (properties are those that do not depend on the amount of material in the system), such as temperature, pressure, and composition, that can be altered without impacting the number of phases in equilibrium.In a single-component system, such as pure water,...
140