[Research on Raman spectra of chalcopyrite under 0-1400 MPa and ambient temperature]
Abstract:
The variation characters of the A1 mode Raman spectra of chalcopyrite under 0.1-1400 MPa and ambient temperature were researched using diamond anvil cell. The results show that the shape and intensity of the Raman peak remains constant under experimental conditions, indicating that the chemical bounds of Cu-S and Fe-S remain unchanged. The authors have also noticed that the position of the Raman peak shifts to higher frequency with increasing pressure, which could be described as: nu(290) = 0.031 2p + 290.60 (0.1< or =p<58.8 MPa) and nu(290) = 0.00572p+292.10 (58.8 < or =p<1400 MPa). The rate of the Raman peak shifting with increasing pressure changed abruptly at about 58.8 MPa, the d(nu)/dp is 31.2 and 5.72 cm(-1) x GPa(-1) below and above 58.8 MPa respectively, which perhaps indicate that some structural changes occurred in the chalcopyrite.
More Related Videos
07:52A Novel Technique for Raman Analysis of Highly Radioactive Samples Using Any Standard Micro-Raman Spectrometer
Published on: April 12, 2017
08:42High-Sensitivity Nuclear Magnetic Resonance at Giga-Pascal Pressures: A New Tool for Probing Electronic and Chemical Properties of Condensed Matter under Extreme Conditions
Published on: October 10, 2014
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
