Evolving anisotropy and degree of elastolytic insult in abdominal aortic aneurysms: potential clinical relevance?

John S Wilson1, J D Humphrey2

  • 1Department of Biomedical Engineering, Yale University, New Haven, CT 06520, USA.

Related Concept Videos

Aneurysm III: Interprofessional Care01:26

Aneurysm III: Interprofessional Care

Aneurysm management involves either conservative medical therapy or surgical intervention, depending on the size and symptoms of the aneurysm. Conservative management is generally reserved for smaller, asymptomatic aneurysms, while larger or symptomatic aneurysms often necessitate surgical repair.Conservative Medical TherapyFor small, asymptomatic aneurysms, particularly abdominal aortic aneurysms (AAA) less than 5.5 centimeters in diameter, conservative medical therapy is recommended. This...
478
Aneurysm II: Clinical Manifestations and Diagnostic Studies01:21

Aneurysm II: Clinical Manifestations and Diagnostic Studies

Thoracic, aortic arch and abdominal aneurysms are significant vascular conditions that can present with various clinical manifestations and lead to serious complications. Understanding these manifestations and the appropriate diagnostic studies is essential for effective management and treatment.Thoracic Aortic AneurysmsThoracic aortic aneurysms often remain asymptomatic until they reach a size that impinges on adjacent structures. They typically cause deep, diffuse chest pain that radiates to...
586
Aneurysm I: Introduction01:30

Aneurysm I: Introduction

An aortic aneurysm is a localized outpouching or dilation at a weak point in the artery wall. It may involve different parts of the aorta, such as the abdominal aorta, aortic arch, or thoracic aorta.Etiological factorsSeveral disorders are associated with aortic aneurysms.Congenital causes, such as primary connective tissue disorders like Marfan syndrome, impact the integrity and strength of connective tissues, notably affecting the aorta. Marfan syndrome is a genetic disorder that specifically...
648
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity01:15

Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity

Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.
821
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
807
Members Made of Elastoplastic Material01:19

Members Made of Elastoplastic Material

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...
535