High-throughput method of dioxin analysis in aqueous samples using consecutive solid phase extraction steps with the...

A high-throughput analytical method has been developed for the determination of seventeen 2,3,7,8-substituted congeners of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in aqueous samples. A recently introduced octadecyl (C18) disk for semi-automated solid-phase extraction of PCDD/Fs in water samples with a high level of particulate material has been tested for the analysis of dioxins. A new type of C18 disk specially designed for the analysis of hexane extractable material (HEM), but never previously reported for use in PCDD/Fs analysis. This kind of disk allows a higher filtration flow, and therefore the time of analysis is reduced. The solid-phase extraction technique is used to change samples from liquid to solid, and therefore pressurized liquid extraction (PLE) can be used in the pre-treatment. In order to achieve efficient purification, extracts from the PLE are purified using an automated Power-prep system with disposable silica, alumina, and carbon columns. Quantitative analyses of PCDD/Fs were performed by GC-HRMS using multi-ion detection (MID) mode. The method was successfully applied to the analysis of water samples from the wastewater treatment system of a vinyl chloride monomer plant. The entire procedure is in agreement with EPA1613 recommendations regarding the blank control, MDLs (method detection limits), accuracy, and precision. The high-throughput method not only meets the requirements of international standards, but also shortens the required analysis time from 2 weeks to 3d.