Related Experiment Video
Updated: Apr 25, 2026

A Test Bed to Examine Helmet Fit and Retention and Biomechanical Measures of Head and Neck Injury in Simulated Impact
Published on: September 21, 2017
Use of body armor protection with fighting load impacts soldier performance and kinematics
Kari L Loverro1, Tyler N Brown2, Megan E Coyne2
1U.S. Army Natick Soldier Research Development and Research Center, Natick, MA, USA; Oak Ridge Institute for Science and Education (ORISE), Belcamp, MD, USA.
Abstract:
The purpose of this evaluation was to examine how increasing body armor protection with and without a fighting load impacted soldiers' performance and mobility. Thirteen male soldiers performed one performance (repeated 30-m rushing) and three mobility tasks (walk, walk over and walk under) with three different body armor configurations and an anterior fighting load. Increasing body armor protection, decreased soldier performance, as individual and total 30-m rush times were significantly longer with greater protection. While increasing body armor protection had no impact on mobility, i.e. significant effect on trunk and lower limb biomechanics, during the walk and walk over tasks, greater protection did significantly decrease maximum trunk flexion during the walk under task. Adding fighting load may negatively impact soldier mobility, as greater maximum trunk extension was evident during the walk and walk over tasks, and decreased maximum trunk flexion exhibited during the walk under task with the fighting load.
More Related Videos
06:20Author Spotlight: Development of an Automated Camera-Based System for Real-Time Blast Overpressure Monitoring and TBI Risk Assessment in Military Training
Published on: December 6, 2024
06:02Disentangling High Strength Copolymer Aramid Fibers to Enable the Determination of Their Mechanical Properties
Published on: September 1, 2018
Related Concept Videos
Impact Loading
In cases of elastic deformation,...
Impact
When particles with different initial velocities collide, they induce deformation by applying equal and opposite impulses. At the point of maximum deformation, the particles move together with...
Personal Protective Equipment
Impact: Problem Solving
By designating the launch point as the origin and utilizing kinematic equations, the vertical component of the projectile's velocity at the point of impact is...
Impulse
Additionally, it can be shown that the...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...