Related Experiment Video

Updated: Apr 19, 2026

Quantitative 31P NMR Analysis of Lignins and Tannins
05:57

Quantitative 31P NMR Analysis of Lignins and Tannins

Published on: August 2, 2021

15.6K

Solid state NMR and IR characterization of wood polymer structure in relation to tree provenance

Ilaria Santoni1, Emanuela Callone2, Anna Sandak1

  • 1Trees and Timber Institute IVALSA/CNR, via Biasi 75, 38010 San Michele All'Adige, Italy.

Carbohydrate Polymers
|December 16, 2014
PubMed

Keywords:
Mid-infrared spectroscopyPCASolid state NMR spectroscopyWood provenance

More Related Videos

Preparation of Fungal and Plant Materials for Structural Elucidation Using Dynamic Nuclear Polarization Solid-State NMR09:37

Preparation of Fungal and Plant Materials for Structural Elucidation Using Dynamic Nuclear Polarization Solid-State NMR

Published on: February 12, 2019

8.0K
Label-free in situ Imaging of Lignification in Plant Cell Walls07:35

Label-free in situ Imaging of Lignification in Plant Cell Walls

Published on: November 1, 2010

13.0K

Related Concept Videos

Introduction to Wood01:19

Introduction to Wood

Wood, derived from trees, is a versatile and widely used construction material. Trees feature a trunk surrounded by a protective layer of dead bark. Beneath this outer layer lies the living bark, followed by the cambium, and then the sapwood which transitions into heartwood as it matures. At the center of the trunk is the pith. The age of a tree can be discerned by examining its growth rings, which are concentric bands visible in the trunk's cross-section.
The structural integrity of the...
1.0K
Softwoods and Hardwoods01:28

Softwoods and Hardwoods

Softwoods and hardwoods, derived from different types of trees, are distinguished by their leaf structures and cellular compositions, each serving unique purposes in construction and manufacturing. Softwoods come from cone-bearing trees with needle-like leaves and are predominantly composed of longitudinal cells called tracheids and a smaller proportion of radial cells known as rays. Due to their cellular structure, softwoods are commonly used in construction for structural frames, sheathing,...
776
NMR Spectroscopy of Aromatic Compounds01:14

NMR Spectroscopy of Aromatic Compounds

Aromatic compounds can be identified or analyzed using proton NMR and carbon‐13 NMR. Typically, aromatic hydrogens or hydrogens directly bonded to the aromatic rings are strongly deshielded by the aromatic ring current. Therefore, they absorb in the range of 6.5–8.0 ppm in proton NMR spectra. For instance, aromatic hydrogens directly bonded to the benzene ring absorb at 7.3 ppm. However, aromatic hydrogens of larger rings absorb farther upfield or downfield than the ideal range.
6.8K
Structural Properties and Dimensions of Lumber01:21

Structural Properties and Dimensions of Lumber

Wood's structural properties derive from fibers aligned along the tree's length, contributing significantly to its mechanical strength. Wood exhibits up to twenty times greater tensile strength along these fibers compared to across them, and generally shows better performance under compression than tension. The length of fibers varies, with hardwoods having fibers around one twenty-fifth inch long and softwoods ranging from one-eighth to one-third inch.
The strength characteristics of...
521
IR Frequency Region: Fingerprint Region01:03

IR Frequency Region: Fingerprint Region

IR spectra are divided into two main regions: the diagnostic region and the fingerprint region. The diagnostic region of the spectrum lies above 1500 cm−1. The absorptions resulting from single-bond vibrations of the N–H, C–H, and O–H stretch at higher wavenumbers and appear on the left side of the spectrum. The stretching absorptions of the C≡C and C≡N occur between 2100–2300 cm−1. In contrast, those arising from stretching absorptions of the...
2.4K
Raman Spectroscopy: Overview01:20

Raman Spectroscopy: Overview

The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
2.7K