Diffusion and Monod kinetics model to determine in vivo human corneal oxygen-consumption rate during soft contact

Luis F Del Castillo1, Ana R Ferreira da Silva2, Saul I Hernández3

  • 1Departamento de Polímeros, Instituto de Investigaciones en Materiales, Universidad Nacional Autónoma de México (UNAM), Ciudad Universitaria, Apartado Postal 70-360, Coyoacán, México, DF 04510, Mexico.

Journal of Optometry
|February 5, 2015
PubMed
Abstract

Related Concept Videos

Physiological Pharmacokinetic Models: Blood Flow-Limited Versus Diffusion-Limited Models00:57

Physiological Pharmacokinetic Models: Blood Flow-Limited Versus Diffusion-Limited Models

Physiological pharmacokinetic models, often called flow-limited or perfusion models, typically assume a swift drug distribution between tissue and venous blood, creating a rapid drug equilibrium. This premise is based on the idea that drug diffusion is extremely fast, and the cell membrane presents no barrier to drug permeation. In this scenario, where no drug binding occurs, the drug concentration in the tissue equals that of the venous blood leaving the tissue. This greatly simplifies the...
470
Passive Diffusion: Overview and Kinetics01:17

Passive Diffusion: Overview and Kinetics

Passive diffusion is a critical process that allows small lipophilic drugs to cross the cell membrane along a concentration gradient. This mechanism's efficiency depends on four primary factors: the membrane's surface area, the drug's lipid-water partition coefficient, the concentration gradient, and the membrane's thickness.
When administered orally, drugs establish a substantial concentration gradient between the gastrointestinal (GI) lumen and the bloodstream, expediting...
1.9K
Nonlinear Pharmacokinetics: Michaelis-Menten Equation01:18

Nonlinear Pharmacokinetics: Michaelis-Menten Equation

The Michaelis–Menten equation is a fundamental model for describing capacity-limited kinetics in drug metabolism. It offers insights into the rate of decline of plasma drug concentration Cp over time, with Vmax and KM as pivotal parameters.
Vmax represents the maximum achievable process rate, while KM, known as the Michaelis constant, signifies the drug concentration at which the process rate reaches half its maximum. This relationship between Vmax, KM, and Cp gives rise to three distinct...
1.4K
Pharmacodynamic Models: Linear Concentration–Effect Model01:15

Pharmacodynamic Models: Linear Concentration–Effect Model

The linear concentration–effect model, underpinned by the principle that pharmacological effect (E) is directly proportional to plasma drug concentration (C), emerges as a pivotal simplification of the Emax model for conditions where C is significantly less than EC50. This model portrays a linear trajectory of the concentration–effect relationship when drug levels are markedly below the EC50 threshold.Despite its inherent assumption of continuous effect augmentation with increasing...
73
Two-Compartment Open Model: Extravascular Administration01:12

Two-Compartment Open Model: Extravascular Administration

The two-compartment model for extravascular administration represents a drug's absorption and distribution process. It features a central compartment, where the drug is first absorbed, and a peripheral compartment, which illustrates the drug's distribution throughout the body. The rate of change in drug concentration in the central compartment is calculated by three exponents: absorption, distribution, and elimination.
The absorption exponent (ka) indicates the speed at which the drug...
856
Pharmacodynamic Models: Logarithmic Concentration–Effect Model01:15

Pharmacodynamic Models: Logarithmic Concentration–Effect Model

The log-linear model is a pharmacological framework used to describe the relationship between drug concentration and its effect. This model is particularly relevant when the observed effects range between 20% and 80% of the drug’s maximum effect (Emax), where a near-linear relationship is observed between the log of drug concentration and the measured effect. However, the log-linear model does not predict the maximum possible effect (Emax) or the effect at zero drug concentration,...
99