[On peculiarities of temperature dependences of water spectra in the terahertz frequency domain]

Related Experiment Video

Updated: Apr 17, 2026

Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere
08:52

Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere

Published on: April 30, 2018

8.8K

N V Penkov, V A Yashin, N E Shvirst

    Biofizika
    |February 24, 2015
    PubMed

    More Related Videos

    Terahertz Microfluidic Sensing Using a Parallel-plate Waveguide Sensor07:28

    Terahertz Microfluidic Sensing Using a Parallel-plate Waveguide Sensor

    Published on: August 30, 2012

    11.2K
    Fabrication and Testing of Photonic Thermometers08:44

    Fabrication and Testing of Photonic Thermometers

    Published on: October 24, 2018

    6.4K

    Related Concept Videos

    IR Spectrum Peak Broadening: Hydrogen Bonding01:23

    IR Spectrum Peak Broadening: Hydrogen Bonding

    The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
    However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular...
    2.3K
    Atomic Spectroscopy: Effects of Temperature01:27

    Atomic Spectroscopy: Effects of Temperature

    Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
    At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
    1.2K
    IR Frequency Region: X–H Stretching01:24

    IR Frequency Region: X–H Stretching

    In IR spectroscopy, signals produced by the X−H bonds (such as C−H, O−H, or N−H) can be observed in the frequency range of  2700–4000 cm–1. The C−H stretching vibration forms sharp bands in the region 2850–3000 cm–1. The presence of the O−H stretching vibration leads to the forming of an absorption band in the frequency range 3650–3200 cm−1. At the same time, N−H stretching can be confirmed by absorption bands in...
    1.8K
    IR Spectrum01:19

    IR Spectrum

    When infrared (IR) radiation passes through a molecule, the bonds stretch or bend by absorbing the radiation. This absorption creates the molecule's absorption spectrum, which is the plot of its percentage transmittance versus wavenumber.
    Transmittance is defined as the ratio of the radiant power passing through a sample to that from the radiation's source. Multiplying the transmittance by 100 gives the percent transmittance (%T), which varies between 100% (no absorption) and 0%...
    3.5K
    IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration01:16

    IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration

    A covalently bonded heteronuclear diatomic molecule can be modeled as two vibrating masses connected by a spring. The vibrational frequency of the bond can be expressed using an equation derived from Hooke's law, which describes how the force applied to stretch or compress a spring is proportional to the displacement of the spring. In this case, the atoms behave like masses, and the bond acts like a spring.
    According to Hooke's law, the vibrational frequency is directly proportional to...
    3.9K
    Spectrophotometry: Introduction01:16

    Spectrophotometry: Introduction

    Spectrophotometry is the quantitative measurement of the absorption, reflection, diffraction, or transmission of electromagnetic radiation through a material as a function of the intensity and wavelength of the radiation. A spectrophotometer is a device used to measure the change in the radiation intensity caused by its interaction with the material.
    The essential components of a spectrophotometer include a source of electromagnetic radiation, a slot for placing a material to be analyzed, and a...
    11.3K