Effects of handle angle and work orientation on hammering: I. Wrist motion and hammering performance

This research investigated the range of wrist motion characteristics associated with the ergonomic principle of "bending the tool and not the wrist" as applied to the hammer. It is thought that bending the tool reduces angular wrist motion, which has been shown in the literature to be a risk factor in hand/wrist disorders such as carpal tunnel syndrome and tenosynovitis. Hammer handles angled at 0 (straight), 20, and 40 deg were investigated in this study. For novices, hammer handles bent at 20 and 40 deg resulted in less total ulnar deviation than straight hammers. However, there was a trade-off in beginning and ending positions of the wrist in that the angled hammers reduced ulnar deviation at the impact position but increased radial deviation at the starting position of a hammer stroke. Handle angle did not significantly affect hammering performance. Wrist motion was affected minimally by hammering orientation, but hammering performance was significantly worse in the wall orientation compared with the bench orientation. This research suggests that for novice users, hammers with handles bent in the range of 20 to 40 deg could possibly decrease the incidence of hand/wrist disorders caused by hammering.