Related Experiment Video
Updated: Apr 15, 2026

Preparation and Friction Force Microscopy Measurements of Immiscible, Opposing Polymer Brushes
Published on: December 24, 2014
Nanostructure and salt effect of zwitterionic carboxybetaine brush at the air/water interface
Hideki Matsuoka1, Yuta Yamakawa1, Arjun Ghosh1
1†Department of Polymer Chemistry, Kyoto University, Katsura, Nishikyo, Kyoto 615-8610, Japan.
Abstract:
Zwitterionic amphiphilic diblock copolymer, poly(ethylhexyl acrylate)-b-poly(carboxybetaine) (PEHA-b-PGLBT), was synthesized by the reversible addition-fragmentation chain transfer (RAFT) method with precise control of block length and polydispersity. The polymers thus obtained were spread onto the water surface to form a polymer monolayer. The fundamental property and nanostructure of the block copolymer monolayer were systematically studied by the surface pressure-molecular area (π-A) isotherm, Brewster angle microscopy (BAM), and X-ray reflectivity (XR) techniques. The π values of the monolayer increased by compression in relatively larger A regions. After showing a large plateau region by compression, the π value sharply increased at very small A regions, suggesting the formation of poly(GLBT) brush formation just beneath the water surface. The domain structure of μm size was observed by BAM in the plateau region. XR profiles for the monolayer at higher surface pressure regions clearly showed the PGLBT brush formation in addition to PGLBT carpet layer formation under the hydrophobic PEHA layer on the water surface, as was observed for both anionic and cationic brush layer in the water surface monolayer studied previously. The critical brush density, where the PGLBT brush is formed, was estimated to be about 0.30 chains/nm(2) for the (EHA)45-b-(GLBT)60 monolayer, which is relatively large compared to other ionic brushes. This observation is consistent with the fact that the origin of brush formation is mainly steric hindrance between brush chains. The brush thickness increased by compression and also by salt addition, unlike the normal ionic brush (anionic and cationic), whose thickness tended to decrease, i.e., shrink, by salt addition. This might be a character unique to the zwitterionic brush, and its origin is thought to be transition to an ionic nature from the almost nonionic inner salt caused by salt addition since both the cation and anion of the GLBT chain obtained counterions by the addition of salt. This stretching nature of the PGLBT brush depends on the ion species of the salt added, and it followed the Hofmeister series, i.e., more stretching in the order of Li(+) > Na(+) > K(+). However, it was rather insensitive to the anion species (Cl(-), Br(-), SCN(-)), which suggests that the carboxylic anion has a more dominant effect than the quaternized cation in GLBT although the former is a weak acid and the latter is believed to be a strong base.
Related Concept Videos
Intermolecular Forces
Surface Active Agents
Colloids
Physical Properties of Carboxylic Acids
Physical Properties of Carboxylic Acid Derivatives
Among the carboxylic acid derivatives, the boiling points of acid chlorides and esters are very similar and are the lowest in the series. Acid anhydrides have slightly higher boiling...
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules,...

