Effect of laser intensity on the characteristic of inkjet-printed silver nanoparticles during continuous laser
Abstract:
The variation in electric conductivity was examined for laser irradiation with various beam intensities. A 532-nm continuous wave laser was irradiated onto inkjet-printed silver lines on a glass substrate and the electrical resistance was measured in situ during the irradiation. The results demonstrate that electrical conductivity varies nonlinearly with laser intensity, and has a minimum specific resistance of 3.1 x 10(-8) Ωm at 4 kW/cm2 irradiation. These results are interesting because the specific resistance achieved by the present laser irradiation was approximately 1.9 times lower than the best value obtainable by oven heating, even though it was still higher by 1.9 times than that of bulk silver. It is also demonstrated that the irradiation time required to complete the sintering process decreases with laser intensity. The numerical simulation of laser heating shows that the heating temperature could be as high as 250 degrees C for laser sintering, while it is limited to 250 degrees C for oven sintering. The characteristics of sintering with laser intensity based on the results of field emission scanning electron microscope images are discussed.
