Exploration of synergistic and redundant information sharing in static and dynamical Gaussian systems

Adam B Barrett1

  • 1Sackler Centre for Consciousness Science, Department of Informatics, University of Sussex, Brighton BN1 9QJ, United Kingdom and Department of Clinical Sciences, University of Milan, Milan 20157, Italy.

Related Concept Videos

Gaussian Elimination: Problem Solving01:30

Gaussian Elimination: Problem Solving

Systems of linear equations in several variables are pivotal in modeling complex scenarios involving multiple unknowns and constraints. Such systems are widely used in various fields to represent relationships where several conditions must be simultaneously satisfied. Each variable in the system corresponds to an unknown quantity, while each equation imposes a linear constraint, leading to a structured approach for analyzing and solving real-world problems.A system of three equations with three...
281
Gauss's Law01:07

Gauss's Law

If a closed surface does not have any charge inside where an electric field line can terminate, then the electric field line entering the surface at one point must necessarily exit at some other point of the surface. Therefore, if a closed surface does not have any charges inside the enclosed volume, then the electric flux through the surface is zero. What happens to the electric flux if there are some charges inside the enclosed volume? Gauss's law gives a quantitative answer to this question.
10.6K
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...
1.1K
¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
1.8K
State Space Representation01:27

State Space Representation

The frequency-domain technique, commonly used in analyzing and designing feedback control systems, is effective for linear, time-invariant systems. However, it falls short when dealing with nonlinear, time-varying, and multiple-input multiple-output systems. The time-domain or state-space approach addresses these limitations by utilizing state variables to construct simultaneous, first-order differential equations, known as state equations, for an nth-order system.
Consider an RLC circuit, a...
733
Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this...
1.6K