Related Experiment Video

Updated: Apr 7, 2026

High-Temperature and High-Pressure In situ Magic Angle Spinning Nuclear Magnetic Resonance Spectroscopy
08:55

High-Temperature and High-Pressure In situ Magic Angle Spinning Nuclear Magnetic Resonance Spectroscopy

Published on: October 9, 2020

6.2K

SULFUR CHEMISTRY. Gas phase observation and microwave spectroscopic characterization of formic sulfuric anhydride

Rebecca B Mackenzie1, Christopher T Dewberry1, Kenneth R Leopold2

  • 1Department of Chemistry, University of Minnesota, 207 Pleasant Street SE, Minneapolis, MN 55455, USA.

Science (New York, N.Y.)
|July 4, 2015
PubMed

More Related Videos

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework11:38

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework

Published on: February 1, 2020

17.1K
Analysis of Volatile and Oxidation Sensitive Compounds Using a Cold Inlet System and Electron Impact Mass Spectrometry05:48

Analysis of Volatile and Oxidation Sensitive Compounds Using a Cold Inlet System and Electron Impact Mass Spectrometry

Published on: September 5, 2014

10.1K

Related Concept Videos

Preparation of Acid Anhydrides01:07

Preparation of Acid Anhydrides

One of the methods for preparing symmetrical or unsymmetrical acid anhydrides involves the treatment of acid chlorides with the sodium salt of carboxylic acids. The reaction proceeds via a nucleophilic acyl substitution.
The carboxylate ion acts as a nucleophile that attacks the carbonyl carbon of the acid chloride to form a tetrahedral intermediate. Subsequently, the re-formation of the carbonyl group with the loss of the chloride ion as a leaving group leads to the formation of an acid...
4.4K
Reactions of Acid Anhydrides01:19

Reactions of Acid Anhydrides

The reactions of acid anhydrides are analogous to the reactions of acid chlorides and proceed via a nucleophilic acyl substitution. They only differ in the identity of the leaving group. During an acid chloride reaction, the leaving group is a chloride ion, and the by-product is hydrochloric acid. However, in an acid anhydride reaction, the leaving group is a carboxylate ion, and the by-product is a carboxylic acid.
5.5K
Atomic Absorption Spectroscopy: Atomization Methods01:25

Atomic Absorption Spectroscopy: Atomization Methods

Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the...
1.9K
Preparation and Reactions of Sulfides02:26

Preparation and Reactions of Sulfides

Sulfides are the sulfur analog of ethers, just as thiols are the sulfur analog of alcohol. Like ethers, sulfides also consist of two hydrocarbon groups bonded to the central sulfur atom. Depending upon the type of groups present, sulfides can be symmetrical or asymmetrical. Symmetrical sulfides can be prepared via an SN2 reaction between 2 equivalents of an alkyl halide and one equivalent of sodium sulfide.
6.0K
IR and UV–Vis Spectroscopy of Carboxylic Acids01:28

IR and UV–Vis Spectroscopy of Carboxylic Acids

In IR spectroscopy of carboxylic acids, the C=O bond shows a characteristic band between 1710 and 1760 cm⁻¹, and the O–H bond exhibits a broad band between 2500 and 3300 cm⁻¹.
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency,...
6.2K
Spectroscopy of Carboxylic Acid Derivatives01:26

Spectroscopy of Carboxylic Acid Derivatives

Infrared spectroscopy is primarily used to determine the types of bonds and functional groups. In carboxylic acid derivatives, a typical carbonyl bond absorption is observed around 1650–1850 cm−1. For esters, the absorption is recorded at around 1740 cm−1, while acid halides show the absorption at about 1800 cm−1. Another acid derivative, the acid anhydrides, exhibit two carbonyl absorption around 1760 cm−1 and 1820 cm−1, arising from the symmetrical and...
3.3K