[Design of partial pelvic replacement with calculation of stresses on the pelvic bone using the finite element...

Although tumors of the pelvic region are relatively rare, with regard to the provision of an individual prosthesis, they make great demands both on the engineer and on the surgeon. In the case of partial pelvic replacement, the main problem is that of fixation. The direction of the preload by the screw and counternut in the anchorage should make possible the introduction of forces into the bone that closely mimic the natural pre-operative situation, in order to keep bone remodeling and stressing to a minimum. A three-dimensional finite element (FE) analysis of the stresses at work in the pelvic bone was performed using an FE model of the pelvis constructed on the basis of computed tomographic data, since with the FE method it is possible to obtain information about deformations, internal stresses and local forces acting on the bone. The results show that the main stressing of the bony pelvis occurs in the region of the acetabulum and the iliosacral joints, and that further points of loading are located in the lower region of the ischium-and this while standing on one leg, on the side of the supporting leg.