Related Experiment Video
Updated: Apr 4, 2026

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Hand Self-Wiping Protocol for the Investigation of Lead Exposure in the Workplace
Jean-Philippe Gorce1, Martin Roff
1a Health and Safety Laboratory , Buxton , United Kingdom.
Abstract:
The purpose of this project was to develop and validate a hand wiping protocol to be used by occupational hygienists, scientists, or other competent persons, measuring skin exposure to lead in workplaces. Inadvertent lead ingestion is likely to occur once the hands of employees have become contaminated. Ideally, a hand wiping protocol should maximize the recovery of lead-based residues present on employees' hands in a cost-effective and reproducible manner. This article describes an effective and practical hand wiping procedure. Here, two standardized protocols (A and B) are designed. Protocol A is a self-wiping protocol requiring employees to wipe their own hands using four separate and successive wipes. Protocol B involves a scientist wiping the hands of employees using four wipes, followed by employees self-wiping their hands using two wipes (total of six wipes). Both protocols are defined by four wipe passes over each hand using Ghost wipes. Because this study took place in the workplace rather than in a simulated laboratory environment, only the relative (i.e., not absolute) removal efficiencies of the hand wiping protocols have been assessed. The two protocols were first evaluated at a double glazing panel manufacturing site where between 248 μg and 4544 μg of lead was found on employees' hands. A statistical analysis (t-test) on the mean relative lead levels recovered in the first parts of the protocols indicated that Protocol A was more efficient than Protocol B (73% for Protocol A vs. 65% for Protocol B). The relative recovery of the combined first two passes against the combined first three passes also confirmed the greater efficiency of Protocol A (83.3% for Protocol A vs. 76.5% for Protocol B). However, lead levels recovered on the fourth pass remain significant at more than 10% of the total recovered loadings. Nonetheless, Protocol A was preferred and further evaluated at a lead battery manufacturing site where between 149 μg and 18,784 μg of lead was found on employees' hands.
More Related Videos
07:20Dried Blood Spot Collection of Health Biomarkers to Maximize Participation in Population Studies
Published on: January 28, 2014
09:33Visualizing Field Data Collection Procedures of Exposure and Biomarker Assessments for the Household Air Pollution Intervention Network Trial in India
Published on: December 23, 2022
Related Concept Videos
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail...
Handwashing III: During the Procedure and Post-Procedure Steps
Standard Precaution
Hand hygiene is the most crucial means to prevent the transmission of disease. Employers are legally required to provide their workers with personal protective equipment (PPE) to minimize exposure or contact with...
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
PPE Use in Healthcare Settings II: Doffing
Hand hygiene
Hand washing...