Overlap between treatment and control distributions as an effect size measure in experiments

Larry V Hedges1, Ingram Olkin2

  • 1Department of Statistics, Northwestern University.

Psychological Methods
|November 3, 2015
PubMed

Related Concept Videos

Sign Test for Matched Pairs01:17

Sign Test for Matched Pairs

The sign test for matched pairs offers a robust method for comparing two paired samples, often for the effects of an intervention in one of them. This method is very useful in situations where the underlying distribution of the data is unknown. The test compares two related samples—often pre- and post-treatment measurements on the same subjects—to determine if there are significant differences in their median values.
To conduct the sign test, we first calculate the differences in...
464
Behrens–Fisher Test00:57

Behrens–Fisher Test

The Behrens-Fisher test is a statistical method designed to address the Behrens-Fisher problem, which arises when comparing the means of two normally distributed populations with unequal variances. Unlike the Student's t-test, which assumes equal variances, the Behrens-Fisher test allows for mean comparison without this restrictive assumption. This flexibility makes it particularly valuable in scenarios where two independent samples exhibit normality but lack variance homogeneity.
This test...
324
F Distribution01:19

F Distribution

The F distribution was named after Sir Ronald Fisher, an English statistician. The F statistic is a ratio (a fraction) with two sets of degrees of freedom; one for the numerator and one for the denominator. The F distribution is derived from the Student's t distribution. The values of the F distribution are squares of the corresponding values of the t distribution. One-Way ANOVA expands the t test for comparing more than two groups. The scope of that derivation is beyond the level of this...
10.9K
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
6.5K
Significance Testing: Overview01:04

Significance Testing: Overview

Significance testing is a set of statistical methods used to test whether a claim about a parameter is valid. In analytical chemistry, significance testing is used primarily to determine whether the difference between two values comes from determinate or random errors. The effect of a particular change in the measurement protocol, analyst, or sample itself can cause a deviation from the expected result. In the case of a suspected deviation/outlier, we need to be able to confirm mathematically...
13.1K
Test for Homogeneity01:23

Test for Homogeneity

The goodness–of–fit test can be used to decide whether a population fits a given distribution, but it will not suffice to decide whether two populations follow the same unknown distribution. A different test, called the test for homogeneity, can be used to conclude whether two populations have the same distribution. To calculate the test statistic for a test for homogeneity, follow the same procedure as with the test of independence. The hypotheses for the test for homogeneity can...
2.5K