Extraction and Analysis of Strontium in Water Sample Using a Sr (2+) Selective Polymer as the Absorbent Phase

A kind of Sr(2+) selective resin was applied as an absorption phase to extract Sr(2+) ion from an aqueous solution, and the amount of Sr(2+) was determined using inductively coupled plasma optical emission spectrometer. Factors, including absorption time, temperature, stirring rate, salt-out effect, desorption, and the pH of the aqueous solution, were investigated to optimize the absorption efficiency of Sr(2+). Foreign ions were examined to observe their effects on the absorption behavior of Sr(2+). The optimum condition was absorption time at 20 min, pH of aqueous solution 7, temperature of 35°C, and 600 rpm stirring rate. A 10 mL solution of 0.1 mol/L HCl is used as the desorption agent. The linear range of Sr(2+) concentrations from 50 to 1200 μg/L was investigated with the slope of 183 μg/L. The limit of detection was 21 μg/L with 4.23% relative standard deviation. The correlation coefficient was found to be 0.9947. Under the optimized conditions, the concentrations of Sr(2+) in four water samples were detected by the developed method. We propose that this method effectively extracts strontium ion from environmental water samples.