Related Experiment Video
Updated: Mar 27, 2026

Preparation of High-Quality Fermented Fish Product
Published on: August 23, 2019
Gelling Properties of Fish/Pork Mince Mixtures
Ru Liu1,2, Siming Zhao1,2,3, Joe M Regenstein4
1College of Food Science and Technology, Huazhong Agricultural Univ, Wuhan, Hubei Province, 430070, P. R. China.
Abstract:
The gel properties of silver carp/pork mince mixtures were investigated as well as the protein structural changes and interactions during gelling using rheology, SEM, and FT-Raman spectroscopy. The breaking force values for gels containing 0% to 40% pork was significantly lower (P < 0.05) compared with gels containing 50% to 100% pork. Gels containing 70% to 100% pork had significantly higher (P < 0.05) breaking force values compared with gels containing 50% to 60% pork. Deformation values were more mixed. Dynamic rheological data suggested that mixing fish and pork at 3:7 could strengthen the gel network. The addition of 40% pork or above, significantly decreased (P < 0.05) the water retention of the gels compared with the 100% fish gels. The dimensional ordering of gels was also reduced by addition of pork. The reduced ordering was one of the reasons for the low water retention for fish/pork mixed gels. Raman spectral analysis confirmed that mixing fish and pork in 7:3 and 3:7 ratios could promote hydrophobic interactions such as bringing tyrosine residues into the intermolecular interface. The interactions in the 3:7 fish/pork mixed gels were favorable for forming a stronger gel. However, the interactions in the 7:3 fish/pork mixed gels were adverse. The water retention of gels was related to both molecular interactions and secondary structures of protein as well as the microstructure of the gels.
More Related Videos
12:22Synthesis of Thermogelling PolyN-isopropylacrylamide-graft-chondroitin Sulfate Composites with Alginate Microparticles for Tissue Engineering
Published on: October 26, 2016
07:26Agarose Fluid Gels Formed by Shear Processing During Gelation for Suspended 3D Bioprinting
Published on: May 26, 2023