Quantifying differences between conditions in single-case designs: Possible analysis and meta-analysis

Rumen Manolov1,2, Antonio Solanas1,2

  • 1a Department of Behavioral Sciences Methods , University of Barcelona , Barcelona , Spain.

Related Concept Videos

Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
11.0K
Cochran's Q Test01:17

Cochran's Q Test

Cochran's Q Test is a nonparametric statistical test used to determine if there are potential differences in the outcomes of three or more related groups on a binary (yes/no) or dichotomous outcome. It is essentially an extension of the McNemar Test, which is limited to two related samples - Cochran's Q test can handle three or more related samples, making it more versatile in scenarios where subjects are measured under multiple conditions. The test statistic follows a Chi-Square...
1.1K
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
15.4K
Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs01:15

Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs

Bioequivalence experimental study designs play a pivotal role in testing the effectiveness of various treatments. Key among these are the repeated measures, cross-over, carry-over, and Latin square designs. In the repeated measures design, each subject receives all treatments, allowing for temporal comparisons. This type of design is useful in reducing variability but requires careful planning to avoid bias.The cross-over design, an economical method, involves sequential administration of...
384
Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
4.6K
One-Way ANOVA: Equal Sample Sizes01:15

One-Way ANOVA: Equal Sample Sizes

One-Way ANOVA can be performed on three or more samples with equal or unequal sample sizes. When one-way ANOVA is performed on two datasets with samples of equal sizes, it can be easily observed that the computed F statistic is highly sensitive to the sample mean.
Different sample means can result in different values for the variance estimate: variance between samples. This is because the variance between samples is calculated as the product of the sample size and the variance between the...
4.4K