Related Experiment Video
Updated: Mar 20, 2026

Evaluating the Effect of Roadside Parking on a Dual-Direction Urban Street
Published on: January 20, 2023
Microscale traffic simulation and emission estimation in a heavily trafficked roundabout in Madrid (Spain)
Christina Quaassdorff1, Rafael Borge1, Javier Pérez1
1Environmental Modelling Laboratory, Department of Chemical and Environmental Engineering, Technical University of Madrid (UPM), c/ José Gutiérrez Abascal 2, 28006 Madrid, Spain.
Abstract:
This paper presents the evaluation of emissions from vehicle operations in a domain of 300m×300m covering a complex urban roundabout with high traffic density in Madrid. Micro-level simulation was successfully applied to estimate the emissions on a scale of meters. Two programs were used: i) VISSIM to simulate the traffic on the square and to compute velocity-time profiles; and ii) VERSIT+micro through ENVIVER that uses VISSIM outputs to compute the related emissions at vehicle level. Data collection was achieved by a measurement campaign obtaining empirical data of vehicle flows and traffic intensities. Twelve simulations of different traffic situations (scenarios) were conducted, representing different hours from several days in a week and the corresponding NOX and PM10 emissions were estimated. The results show a general reduction on average speeds for higher intensities due to braking-acceleration patterns that contribute to increase the average emission factor and, therefore, the total emissions in the domain, especially on weekdays. The emissions are clearly related to traffic volume, although maximum emission scenario does not correspond to the highest traffic intensity due to congestion and variations in fleet composition throughout the day. These results evidence the potential that local measures aimed at alleviating congestion may have in urban areas to reduce emissions. In general, scenario-averaged emission factors estimated with the VISSIM-VERSIT+micro modelling system fitted well those from the average-speed model COPERT, used as a preliminary validation of the results. The largest deviations between these two models occur in those scenarios with more congestion. The design and resolution of the microscale modelling system allow to reflect the impact of actual traffic conditions on driving patterns and related emissions, making it useful for the design of mitigation measures for specific traffic hot-spots.
More Related Videos
Related Concept Videos
Turnover Number and Catalytic Efficiency
Chymotrypsin is a pancreatic enzyme that breaks down proteins during digestion....
Net Torque Calculations
Rolling Resistance: Problem Solving

