Related Experiment Video

Updated: Mar 19, 2026

Age-dependent Dynamics of Locomotion in Caenorhabditis elegans: A Lyapunov Exponent Analysis
06:44

Age-dependent Dynamics of Locomotion in Caenorhabditis elegans: A Lyapunov Exponent Analysis

Published on: September 23, 2025

680

Bifurcation and scaling at the aging transition boundary in globally coupled excitable and oscillatory units

Hiroaki Daido1, Kazuho Nishio1

  • 1Department of Mathematical Sciences, Graduate School of Engineering, Osaka Prefecture University, Sakai 599-8531, Japan.

Physical Review. E
|June 15, 2016
PubMed

More Related Videos

Generation of Local CA1 γ Oscillations by Tetanic Stimulation08:02

Generation of Local CA1 γ Oscillations by Tetanic Stimulation

Published on: August 14, 2015

9.6K
A Microfluidics Approach for the Functional Investigation of Signaling Oscillations Governing Somitogenesis08:06

A Microfluidics Approach for the Functional Investigation of Signaling Oscillations Governing Somitogenesis

Published on: March 19, 2021

3.3K

Related Concept Videos

Scaling01:26

Scaling

In designing and analyzing filters, resonant circuits, or circuit analysis at large, working with standard element values like 1 ohm, 1 henry, or 1 farad can be convenient before scaling these values to more realistic figures. This approach is widely utilized by not employing realistic element values in numerous examples and problems; it simplifies mastering circuit analysis through convenient component values. The complexity of calculations is thereby reduced, with the understanding that...
631
Current Growth And Decay In RL Circuits01:30

Current Growth And Decay In RL Circuits

The current growth and decay in RL circuits can be understood by considering a series RL circuit consisting of a resistor, an inductor, a constant source of emf, and two switches. When the first switch is closed, the circuit is equivalent to a single-loop circuit consisting of a resistor and an inductor connected to a source of emf. In this case, the source of emf produces a current in the circuit. If there were no self-inductance in the circuit, the current would rise immediately to a steady...
4.8K
Limits with Oscillating Discontinuities01:19

Limits with Oscillating Discontinuities

An oscillating discontinuity is a type of discontinuity in which a function’s values fluctuate infinitely often as the input approaches a particular point. Unlike jump discontinuities, where the function suddenly shifts between two values, or infinite discontinuities, where the function diverges without bound, an oscillating discontinuity arises from rapid back-and-forth variation. Because the function never stabilizes toward a single value, no finite limit exists at that point.One of the...
591
Transmission-Line Differential Equations01:26

Transmission-Line Differential Equations

Transmission lines are essential components of electrical power systems. They are characterized by the distributed nature of resistance (R), inductance (L), and capacitance (C) per unit length. To analyze these lines, differential equations are employed to model the variations in voltage and current along the line.
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured from...
1.1K
Exponential Equations for Modeling Growth01:26

Exponential Equations for Modeling Growth

Exponential models are essential for describing rapid, multiplicative changes in natural systems, such as population growth. When a population doubles at regular intervals, the process can be modeled using a suitable base. For instance, a bacterial culture that doubles every three hours follows the model n(t)=n0⋅2t/3, where n(t) is the population at the time t.A more general model uses the natural base e, especially for continuous growth. This takes the form n(t)=n0⋅ert, where r is...
409
BIBO stability of continuous and discrete -time systems01:24

BIBO stability of continuous and discrete -time systems

System stability is a fundamental concept in signal processing, often assessed using convolution. For a system to be considered bounded-input bounded-output (BIBO) stable, any bounded input signal must produce a bounded output signal. A bounded input signal is one where the modulus does not exceed a certain constant at any point in time.
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....
1.0K