Seasonal Mass Changes and Crustal Vertical Deformations Constrained by GPS and GRACE in Northeastern Tibet

Yuanjin Pan1, Wen-Bin Shen2,3, Cheinway Hwang4,5

  • 1School of Geodesy and Geomatics, Wuhan University, Wuhan 430079, China. pan_yuanjin@163.com.

Related Concept Videos

Variation in Acceleration due to Gravity near the Earth's Surface01:20

Variation in Acceleration due to Gravity near the Earth's Surface

An object's apparent weight is its weight measured by a spring balance at its location. It is different from its true weight, the force with which the Earth pulls it, because of the Earth's rotation. Mathematically, an object's apparent weight equals its true weight minus the centripetal force that keeps it in a circular motion along with the Earth's surface every 24 hours.
The difference between the true and apparent weights is proportional to the square of the Earth's...
2.9K
Geoid and Ellipsoid01:28

Geoid and Ellipsoid

The Earth's shape is best described as an ellipsoid, a slightly flattened sphere created by rotating an ellipse around its minor axis. This flattening results in the polar axis being about 21 kilometers shorter than the equatorial axis. In contrast, the geoid represents the Earth's gravitational shape and aligns with the mean sea level (MSL). The geoid is an irregular equipotential surface where gravity is perpendicular at every point. Variations in Earth's mass distribution cause geoid...
975
Precipitation Gravimetry01:03

Precipitation Gravimetry

Precipitation gravimetry is based on converting an analyte into a sparingly soluble precipitate, which is separated by filtration and weighed. An ideal precipitate should be pure, insoluble, of known composition, and easily filtered from the reaction mixture.
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...
16.0K
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
495
Frequency of Spring-Mass System01:17

Frequency of Spring-Mass System

One interesting characteristic of the simple harmonic motion (SHM) of an object attached to a spring is that the angular frequency, and the period and frequency of the motion, depend only on the mass and the force constant of the spring, and not on other factors such as the amplitude of the motion or initial conditions. We can use the equations of motion and Newton's second law to find the angular frequency, frequency, and period.
Consider a block on a spring on a frictionless surface. There...
8.2K
Design Example: Identifying the Locations of Monuments in the Field Using Global Positioning System Device01:30

Design Example: Identifying the Locations of Monuments in the Field Using Global Positioning System Device

Surveyors use Global Positioning System (GPS) technology to measure the precise location and elevation of points on Earth. In a recent survey, GPS receivers were used to determine the coordinates and elevations of two park monuments. The process involved careful mission planning, data collection, and correction to ensure accuracy. The survey began with mission planning to identify optimal satellite visibility and minimize Position Dilution of Precision (PDOP). A geodetic control point...
443