Related Experiment Video

Updated: Mar 16, 2026

Precision Milling of Carbon Nanotube Forests Using Low Pressure Scanning Electron Microscopy
08:10

Precision Milling of Carbon Nanotube Forests Using Low Pressure Scanning Electron Microscopy

Published on: February 5, 2017

7.9K

Effect of Topological Defects on Buckling Behavior of Single-walled Carbon Nanotube

Ali Reza Ranjbartoreh1,2, Guoxiu Wang3

  • 1School of Mechanical Engineering, Faculty of Engineering, University of Technology Sydney, Office 3. 29, Building 4, Harris St, Broadway, Sydney, NSW, 2007, Australia. Aranjbar@uow.edu.au.

Nanoscale Research Letters
|August 10, 2016
PubMed

Keywords:
BucklingMolecular dynamic simulationSingle vacancy (SV) defectSingle-walled carbon nanotube (SWCNT)Stone–Wales (SW) defect

More Related Videos

Facile Preparation of Internally Self-assembled Lipid Particles Stabilized by Carbon Nanotubes09:47

Facile Preparation of Internally Self-assembled Lipid Particles Stabilized by Carbon Nanotubes

Published on: February 19, 2016

10.2K
Fabrication of Low Temperature Carbon Nanotube Vertical Interconnects Compatible with Semiconductor Technology09:20

Fabrication of Low Temperature Carbon Nanotube Vertical Interconnects Compatible with Semiconductor Technology

Published on: December 7, 2015

8.2K

Related Concept Videos

Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
574
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
687
Stresses under Combined Loadings01:23

Stresses under Combined Loadings

When analyzing a bent tube with a circular cross-section subjected to multiple forces, it is crucial to determine the stress distribution in order to maintain structural integrity under varied load conditions.
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
521