Related Experiment Video
Updated: Mar 13, 2026

Postural Organization of Gait Initiation for Biomechanical Analysis Using Force Platform Recordings
Published on: July 26, 2022
Effect of posture on the aerodynamic characteristics during take-off in ski jumping
Keizo Yamamoto1, Makoto Tsubokura2, Jun Ikeda3
1School of Lifelong Sport, Hokusho University, 23 Bunkyodai, Ebetsu, Hokkaido 069-8511, Japan.
Abstract:
The purpose of this study was to investigate the effects of posture of a ski jumper on aerodynamic characteristics during the take-off using computational fluid dynamics (CFD). The CFD method adopted for this study was based on Large-Eddy Simulation. Body surface data were obtained by 3-D laser scanning of an active ski jumper. Based on video analysis of the actual take-off movement, two sets of motion data were generated (world-class jumper A and less-experienced jumper B). The inlet flow velocity that corresponds to the in-run velocity in actual ski jumping was set to 23.23m/s in the CFD. The aerodynamic force, flow velocity, and vortexes for each model were compared between models. The total drag force acting upon jumper A was lower than that acting upon jumper B through the whole movement. Regarding the total lift force, although jumper A׳s total lift force was less in the in-run posture, it became greater than that of jumper B at the end of the movement. In the latter half of the movement, low air-speed domain expansion was observed at the model׳s back. This domain of jumper B was larger. There were two symmetric vortexes in the wake of jumper A, but the disordered vortexes were observed behind the jumper B. In the case of jumper A, these two distinct vortexes generated by the arms produced a downwash flow in the wake. It is considered that the positioning of the arms in a very low position strongly influences the flow structure.
Related Concept Videos
Motion of a Projectile
Horizontal motion, governed by the initial kick, maintains a constant velocity throughout the flight of the soccer ball.
Lift
Impact: Problem Solving
By designating the launch point as the origin and utilizing kinematic equations, the vertical component of the projectile's velocity at the point of impact is...
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
Energy Diagrams - I
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...

