Related Experiment Video
Updated: Mar 13, 2026
In Vitro Evaluation of The Effects Of Er,Cr:YSGG and Diode Lasers Used on Titanium Cylinder
Published on: June 6, 2025
A parametric study of laser interference surface patterning of dental zirconia: Effects of laser parameters on
Erica Roitero1, Federico Lasserre2, Marc Anglada3
1Material Science and Metallurgical Engineering Department. Barcelona Engineering School (EEBE) Universitat Politècnica de Catalunya- Barcelona TECH C. Eduard Maristany, 10-14, 08019 Barcelona, Spain; Centre for Research in Nanoengineering, CRnE, Univerisitat Politèncica de Catalunya, C. Pascual i Vila 15, Barcelona 08028, Spain; Department of Materials Science and Engineering, Saarland University, Saarbrucken 66123, Germany.
Objective:
The aim of this work is to generate micrometric linear patterns with different topography on dental grade zirconia by means of UV laser interference and to assess the quality of the produced surface, both in term of the geometry produced and of the surface damage induced in the material.
Methods:
The third harmonic of a Q-switched Nd:YAG laser (355nm, pulse duration of 10ns and repetition rate of 1Hz) was employed to pattern the surface of 3Y-TZP with micrometric-spaced lines. The resulting topography was characterized with White Light Interferometry and Scanning electron microscopy: pattern depth (H), amplitude roughness parameters (Sa, filtered-Sa), Fourier spatial analysis and collateral damages were related to laser fluence and number of pulses employed.
Results:
With our experimental setup, line-patterning of zirconia surfaces can be achieved with periodicities comprised within 5 and 15μm. Tuning laser parameters allows varying independently pattern depth, overall roughness and surface finish. Increasing both fluence and number of pulses allows producing deeper patterns (maximum achievable depth of 1μm). However, increasing the number of pulses has a detrimental effect on the quality of the produced lines. Surface damage (intergranular cracking, open porosity and nano-droplets formation) can be generated, depending on laser parameters.
Significance:
This work provides a parametric analysis of surface patterning by laser interference on 3Y-TZP. Best conditions in terms of quality of the produced pattern and minimum material damage are obtained for low number of pulses with high laser fluence. With the employed method we can produce zirconia materials with controlled topography that are expected to enhance biological response and mechanical performance of dental components.
