Related Experiment Video
Updated: Mar 12, 2026

The Synthesis of RGD-functionalized Hydrogels as a Tool for Therapeutic Applications
Published on: October 7, 2016
Synthesis, characterization and modification of Gum Arabic microgels for hemocompatibility and antimicrobial studies
Muhammad Farooq1, Selin Sagbas2, Mehtap Sahiner3
1Department of Chemistry, Quaid-i-Azam University, Islamabad 45320, Pakistan.
Abstract:
Gum Arabic (GA) microgels were successfully prepared via reverse micellization method with high yield (78.5±5.0%) in 5-100μm size range using divinyl sulfone (DVS) as a crosslinker. The GA microgels were degraded hydrolytically 22.8±3.5% at pH 1 in 20days, whereas no degradation was observed at pH 7.4 and pH 9 at 37°C. By using diethylenetriamine (DETA), and taurine (TA) as chemical modifying agents, GA microgels were chemically modified as GA-DETA and GA-TA, and the zeta potential values of 5.2±4.1 and -24.8±1.3mV were measured, respectively in comparison to -27.3±4.2mV for GA. Moreover, blood compatibility of GA, GA-TA, and GA-DETA microgels was tested via in vitro protein adsorption, % hemolysis ratio, and blood clotting index. All the microgels were hemocompatible with% hemolysis ratio between 0.23 to 2.05, and the GA microgels were found to be highly compatible with a blood clotting index of 81±40. The biocompatibility of GA, GA-DETA and GA-Taurine microgels against L929 fibroblast cells also revealed 84.4, 89.1, and 67.0% cell viability, respectively, at 25.0μg/mL concentration, suggesting great potential in vivo biomedical applications up to this concentration. In addition, 5 and 10mg/mL minimum inhibition concentrations of protonated GA-DETA microgels (GA-DETA-HCl) were determined against E. coli and S. aureus, respectively.
More Related Videos
12:22Synthesis of Thermogelling PolyN-isopropylacrylamide-graft-chondroitin Sulfate Composites with Alginate Microparticles for Tissue Engineering
Published on: October 26, 2016
10:36Gelatin Methacryloyl Granular Hydrogel Scaffolds: High-throughput Microgel Fabrication, Lyophilization, Chemical Assembly, and 3D Bioprinting
Published on: December 9, 2022