RETRACTED: Coseismic rupturing stopped by Aso volcano during the 2016 Mw 7.1 Kumamoto earthquake, Japan

A Lin1, T Satsukawa1, M Wang1

  • 1Department of Geophysics, Graduate School of Science, Kyoto University, Kyoto 606-8502, Japan.

Science (New York, N.Y.)
|November 19, 2016
PubMed

Related Concept Videos

Restarting Stalled Replication Forks02:37

Restarting Stalled Replication Forks

2.4K
Restarting Stalled Replication Forks02:37

Restarting Stalled Replication Forks

DNA replication is initiated at sites containing predefined DNA sequences known as origins of replication. DNA is unwound at these sites by the minichromosome maintenance (MCM) helicase and other factors such as Cdc45 and the associated GINS complex.The unwound single strands are protected by replication protein A (RPA) until DNA polymerase starts synthesizing DNA at the 5’ end of the strand in the same direction as the replication fork. To prevent the replication fork from falling apart,...
6.5K
Destabilization of Microtubules01:45

Destabilization of Microtubules

The destabilization of microtubules can occur during different stages of the microtubule lifecycle, such as nucleation or elongation. It can take place at either end of the microtubule or in the microtubule lattices as a whole. The lifespan of individual microtubules within a cell varies according to the cell type and stage of the cell cycle. During interphase, the lifespan of the microtubule is about 30 minutes, while during cell division, it is about 15 minutes. In axonal microtubules of...
3.8K
Fault Types01:18

Fault Types

When analyzing a single line-to-ground fault from phase A to ground at a three-phase bus, it is important to consider the fault impedance. This impedance is zero for a bolted fault, equal to the arc impedance for an arcing fault, and represents the total fault impedance for a transmission-line insulator flashover. To derive sequence and phase currents, fault conditions are translated from the phase domain to the sequence domain.
For line-to-line faults occurring between phases B and C, the...
473
Elastic Collisions: Case Study01:15

Elastic Collisions: Case Study

Elastic collision of a system demands conservation of both momentum and kinetic energy. To solve problems involving one-dimensional elastic collisions between two objects, the equations for conservation of momentum and conservation of internal kinetic energy can be used. For the two objects, the sum of momentum before the collision equals the total momentum after the collision. An elastic collision conserves internal kinetic energy, and so the sum of kinetic energies before the collision equals...
20.9K
Carbonation Shrinkage01:24

Carbonation Shrinkage

Atmospheric CO2 penetrates the concrete's pores and, in the presence of moisture, forms carbonic acid, which then reacts with calcium hydroxide in the hydrated cement, forming calcium carbonate. This process reduces the concrete's volume and is termed carbonation shrinkage.
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction...
533