Related Experiment Video
Updated: Mar 3, 2026

Fabrication of Schottky Diodes on Zn-polar BeMgZnO/ZnO Heterostructure Grown by Plasma-assisted Molecular Beam Epitaxy
Published on: October 23, 2018
Subthreshold swing improvement in MoS2 transistors by the negative-capacitance effect in a ferroelectric
Amirhasan Nourbakhsh1, Ahmad Zubair, Sameer Joglekar
1Department of Electrical Engineering and Computer Sciences, Massachusetts Institute of Technology, Cambridge, Massachusetts 02139, USA. anour@mit.edu.
Abstract:
Obtaining a subthreshold swing (SS) below the thermionic limit of 60 mV dec-1 by exploiting the negative-capacitance (NC) effect in ferroelectric (FE) materials is a novel effective technique to allow the reduction of the supply voltage and power consumption in field effect transistors (FETs). At the same time, two-dimensional layered semiconductors, such as molybdenum disulfide (MoS2), have been shown to be promising candidates to replace silicon MOSFETs in sub-5 nm-channel technology nodes. In this paper, we demonstrate NC MoS2 FETs by incorporating a ferroelectric Al-doped HfO2 (Al : HfO2), a technologically compatible material, in the FET gate stack. Al : HfO2 thin films were deposited on Si wafers by atomic layer deposition. Voltage amplification up to 1.25 times was observed in a FE bilayer stack of Al : HfO2/HfO2 with a Ni metallic intermediate layer. The minimum SS (SSmin) of the NC-MoS2 FET built on the FE bilayer improved to 57 mV dec-1 at room temperature, compared with SSmin = 67 mV dec-1 for the MoS2 FET with only HfO2 as a gate dielectric.
More Related Videos
Related Concept Videos
MOS Capacitor
The metal gate is typically made from highly conductive materials such as aluminum or polysilicon. Beneath the metal gate lies a thin layer of...
Characteristics of MOSFET
Various vital parameters influence their functionality, which is crucial for theory and electronics applications. First, channel dimensions, precisely length, and width, are pivotal. The size of these channels affects the transistor's ability to carry current and switching speeds; shorter channels typically enable...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...
MOSFET
In an n-MOSFET, the structure includes n-type source and drain...
MOSFET Amplifiers

