EXPERIMENTAL TESTS OF FOUNDER-FLUSH: A REPLY TO TEMPLETON

A complete procedure of testing a hypothesis about a population mean when the population standard deviation is unknown is explained here.
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...

Fisher's exact test is a statistical significance test widely used to analyze 2x2 contingency tables, particularly in situations where sample sizes are small. Unlike the chi-squared test, which approximates P-values and assumes minimum expected frequencies of at least five in each cell, Fisher's exact test calculates the exact probability (P-value) of observing the data or more extreme results under the null hypothesis. This feature makes it especially valuable when the assumptions of...

In statistics, the term independence means that one can directly obtain the probability of any event involving both variables by multiplying their individual probabilities. Tests of independence are chi-square tests involving the use of a contingency table of observed (data) values.
The test statistic for a test of independence is similar to that of a goodness-of-fit test:

Significance testing is a set of statistical methods used to test whether a claim about a parameter is valid. In analytical chemistry, significance testing is used primarily to determine whether the difference between two values comes from determinate or random errors. The effect of a particular change in the measurement protocol, analyst, or sample itself can cause a deviation from the expected result. In the case of a suspected deviation/outlier, we need to be able to confirm mathematically...

The outcome of any hypothesis testing leads to rejecting or not rejecting the null hypothesis. This decision is taken based on the analysis of the data, an appropriate test statistic, an appropriate confidence level, the critical values, and P-values. However, when the evidence suggests that the null hypothesis cannot be rejected, is it right to say, 'Accept' the null hypothesis?
There are two ways to indicate that the null hypothesis is not rejected. 'Accept' the null...

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...