Ultrasound-guided block and the incidence of intraneural injection. A reply

Intravenous regional anesthesia or the Bier block technique is used to anesthetize a specific limb or extremity. It uses exsanguinated or blood-drained vessels to transport local anesthetics or LAs to the peripheral nerve trunks. Lidocaine without vasoconstrictors like epinephrine is most commonly used for this technique. Other drugs used are prilocaine, ropivacaine, and chloroprocaine. Bupivacaine is not recommended for this technique due to its high cardiac toxicity.
One of the advantages of...

Spinal anesthetics are given during lower abdomen and limb surgeries to block sensory and motor neurons. They are administered in the mid to low lumbar regions, primarily acting on the cauda equina's nerve roots. The blockade level depends on the local anesthetic (LA) concentration. Usually, low LA concentrations are sufficient to block sensory fibers, while only high LA concentrations block motor fibers. Other factors like injection volume and speed, the patient's posture, and the drug...

Depending on the target organ, local anesthetics (LAs) can be administered via various routes. In surface anesthesia, LAs are applied directly to the surface of the skin or mucous membranes. It is widely used for topical skin numbing before venipuncture or minor surgical procedures. Commonly used surface local anesthetics are lidocaine or benzocaine sprays or creams. Surface anesthesia occurs within 5 minutes and lasts for about 60 minutes. One of the main disadvantages of topical anesthesia is...

Depolarizing blockers are administered through intravenous injection. Succinylcholine is the most common choice of depolarizing blockers in emergency clinical practices. Although they have a rapid onset, they readily diffuse away from the motor end plate into the extracellular fluid. They are metabolized by enzymes such as liver butyrylcholinesterase and plasma pseudocholinesterases. This produces a short duration of action, typically 5-10 minutes long, unlike nondepolarizing blockers, which...

All neuromuscular blocking agents are injected intravenously because they are poorly absorbed from the GI tract. Rapid onset is achieved with intravenous administration, although absorption is also adequate from an intramuscular injection. Since these agents are highly ionized, they do not readily penetrate cell membranes or cross the blood-brain barrier.
Instead, they are transported by the blood to different tissues. Muscles with a greater blood supply (arteries) and blood flow receive more...