Measurement of the mechanical properties of the human gallbladder

Gallbladder is a small organ of the body which is located in the right side of the liver. It is responsible of storing the bile and releasing it to the intestine. The gallbladder can subject to the mechanical deformation/loading as a result of the cholecystitis, cholesterolosis of the gallbladder, etc. However, so far the mechanical properties of the human gallbladder have not been measured. This study was aimed at conducting an experimental study to measure the mechanical properties of the human gallbladder under the axial and transversal tensile loadings. To do that, the gallbladder tissue of 16 male individuals was excised during the autopsy and subjected to a series of axial and transversal loadings under the strain rate of 5 mm/min. The amount of elastic modulus as well as the maximum/failure stress of the tissues were calculated via the resulted stress-strain diagrams and reported. The results revealed that the axial and transversal elastic modulus were 641.20 ± 28.12 (mean ± SD) and 255 ± 24.55 kPa, respectively. The amount of maximum stresses was also 1240 ± 99.94 and 348 ± 66.75 kPa under the axial and transversal loadings, respectively. The results revealed a significantly higher axial stiffness (p < .05, post hoc Scheffe method) compared to the transversal one. These findings have implications not only for understanding the axial and transversal mechanical properties of the human gallbladder tissue, but also for providing a diagnosis tool for the doctors to have a suitable threshold value of the healthy gallbladder tissue.