Related Experiment Video
Updated: Feb 23, 2026

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Using environmental engineering to increase hand hygiene compliance: a cross-over study protocol
Kelly Ann Schmidtke1, Navneet Aujla1, Tom Marshall1,2
1Behavioural Science Group, Warwick Business School, The University of Warwick, Coventry, UK.
Introduction:
Compliance with hand hygiene recommendations in hospital is typically less than 50%. Such low compliance inevitably contributes to hospital-acquired infections that negatively affect patients' well-being and hospitals' finances. The design of the present study is predicated on the assumption that most people who fail to clean their hands are not doing so intentionally, they just forget. The present study will test whether psychological priming can be used to increase the number of people who clean their hands on entering a ward. Here, we present the protocol for this study.
Methods And Analysis:
The study will use a randomised cross-over design. During the study, each of four wards will be observed during four conditions: olfactory prime, visual prime, both primes and neither prime. Each condition will be experienced for 42 days followed by a 7-day washout period (total duration of trial=189 days). We will record the number of people who enter each ward and whether they clean their hands during observation sessions, the amount of cleaning material used from the dispensers each week and the number of hospital-acquired infections that occur in each period. The outcomes will be compared using a regression analysis. Following the initial trail, the most effective priming condition will be rolled out for 3 months in all the wards.
Ethics And Dissemination:
Research ethics approval was obtained from the South Central-Oxford C Research Ethics Committee (16/SC/0554), the Health Regulatory Authority and the sponsor.
Trial Registration Number:
ISRCTN (15397624); Edge ID 86357.
More Related Videos
07:13Swabbing the Urban Environment - A Pipeline for Sampling and Detection of SARS-CoV-2 From Environmental Reservoirs
Published on: April 9, 2021
08:33A Cross-Disciplinary and Multi-Modal Experimental Design for Studying Near-Real-Time Authentic Examination Experiences
Published on: September 4, 2019
Related Concept Videos
Handwashing III: During the Procedure and Post-Procedure Steps
Hand hygiene
Hand washing...
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail...
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
Standard Precaution
Hand hygiene is the most crucial means to prevent the transmission of disease. Employers are legally required to provide their workers with personal protective equipment (PPE) to minimize exposure or contact with...
Healthcare Associated Infections II: Preventive Measures
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...