Using a fluorescence quenching method to detect DNA adsorption onto single-walled carbon nanotube surfaces

Surface modification of single-walled carbon nanotubes (SWNTs) with DNA molecules has attracted much attention in recent years to increase SWNT solubility and make various SWNT-based nanobiodevices. Therefore, there is a critical need to quantify the interaction between DNA molecules and SWNT surfaces, particularly the intermediate structures during DNA adsorption. In this study, we demonstrate the ability to detect the adsorption of DNA oligomers on SWNT surfaces by fluorescence spectroscopy. Fluorescein-labelled, 30mer, thymine oligonucleotides (F-T30) were employed as a fluorescent probe to study the interaction of DNA with SWNTs. A clear quenching effect was observed when F-T30 was adsorbed onto SWNT surfaces. Using this method, the amount of DNA adsorbed onto the SWNT surfaces was measured under different sonication conditions to correlate adsorption efficiency with sonication strength and duration. When a bath-type sonicator was used, mild adsorption of F-T30 on SWNT surfaces was observed. Furthermore, a two-step adsorption was observed in this condition. In contrast, we observed rapid adsorption of F-T30 to SWNT surfaces at the higher sonication amplitude (60% maximal) using a probe-type sonicator, while only slight adsorption of DNA molecules was observed at the lower amplitude (20% maximal). Our data revealed that the quenching effect can be used to evaluate DNA adsorption onto SWNT surfaces. In addition, atomic force microscopy (AFM) and photoacoustic spectroscopy (PAS) were conducted to provide complementary information on the DNA-SWNT nanoconjugates.