Related Experiment Video
Updated: Feb 20, 2026
Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer
Published on: April 19, 2021
The Effect of Solutes on the Temperature of Miscibility Transitions in Multicomponent Membranes
1Department of Physics, Kent State University, Kent, Ohio; Department of Physics, University of Washington, Seattle, Washington.
Abstract:
We address questions posed by experiments that show small-chain alcohols reduce the miscibility transition temperature when added to giant plasma membrane vesicles (GPMVs), but increase that temperature when added to giant unilamellar vesicles. In giant unilamellar vesicles the change in temperature displays a definite minimum, between decanol and tetradecanol, as a function of alcohol chain length; in GPMVs there is no such minimum. To emphasize the competition between internal entropies of the components and the interactions between them, we model the system as consisting of three different linear polymers. Two of them are the constituents of a liquid, one that can undergo a miscibility transition. To this liquid is added the third polymer component, which represents the short-chain alcohol. We show that, within Flory-Huggins theory, the addition of alcohol causes an increase or decrease of the miscibility transition temperature depending upon the competition of two effects. The first is the dilution of the interactions between the two components of the liquid caused by the introduction of the alcohol. This tends to lower the transition temperature. The second effect is the preferential partitioning of the alcohol into one phase of the liquid or the other. This tends to raise the transition temperature irrespective of which phase the alcohol prefers. This second effect is the smallest, and the decrease in transition temperature the largest, when the alcohol partitions equally between the two phases. Such equal partitioning occurs when the effect of the entropic excluded volume interactions (which cause the alcohol to prefer one phase) just balances the effect of the direct interactions, which cause it to prefer the other. These results allow us to make several predictions, and to propose an explanation for the different behavior of the transition temperature in GPMVs and giant unilamellar vesicles that results from the addition of alcohols.
Related Concept Videos
02:34Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
03:00Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules,...
02:35Energetics of Solution Formation
When the strengths of the intermolecular forces of attraction between solute and solvent species in a solution are no different than those present in the separated components, the solution is formed with no accompanying energy change. Formation of the solution requires the solute–solute and solvent–solvent...
02:19Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
02:39Phase Transitions: Melting and Freezing
03:12Freezing Point Depression and Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...