Validation of differential cross sections by means of 252Cf spectral averaged cross sections
Martin Schulc1, Michal Košťál1, Stanislav Simakov2
1Research Centre Rez Ltd, 250 68 Husinec-Řež 130, Czech Republic.
Abstract:
The results of systematic evaluations of the spectrum-averaged cross section measurements performed in the spontaneous fission 252Cf neutron field are presented. The Following threshold reactions were investigated: 23Na(n,2n)22Na, 54Fe(n,p)54Mn, 54Fe(n,α) 51Cr, 27Al(n,p)27Mg, 27Al(n,α)24Na, 19F(n,2n)18F, 90Zr(n,2n)89Zr and 89Y(n,2n)88Y. The spectrum-averaged cross sections for 23Na(n,2n)22Na, 54Fe(n,α)51Cr and 89Y(n,2n)88Y reactions were measured for the first time. This quantity is compared with calculations carried with the IRDFF-v1.05 library. There is a notable disagreement exceeding uncertainties only for 54Fe(n,p)54Mn and 54Fe(n,α) 51Cr reactions. The spectrum-averaged cross sections were inferred from experimentally determined reaction rates. The experimental reaction rates were derived for irradiated samples from the Net Peak Areas measured using the semiconductor high purity germanium spectroscopy. The presented experimental data can be used to validate nuclear data libraries and reactions used in the practical reactor dosimetry and to specify high energy tail of the 252Cf neutron spectrum.
Related Concept Videos
¹³C NMR: ¹H–¹³C Decoupling
A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
Atomic Emission Spectroscopy: Overview
Atomic Absorption Spectroscopy: Instrumentation
The atomizer used in AAS can be either a flame atomizer or an...
Atomic Absorption Spectroscopy: Radiation and Light Sources
Two common narrow-range 'line' sources used in AAS are hollow-cathode lamps (HCLs) and...
Atomic Absorption Spectroscopy: Lab
Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing...
Atomic Absorption Spectroscopy: Interference
Spectral interference occurs when signals from other elements or molecules overlap with the analyte signal, falsely elevating or masking the analyte's absorbance. This interference can be corrected using Zeeman,...


