Related Experiment Video
Updated: Feb 18, 2026

Removal of Arsenic Using a Cationic Polymer Gel Impregnated with Iron Hydroxide
Published on: June 28, 2019
Highly selective and efficient adsorption of Hg2+ by a recyclable aminophosphonic acid functionalized
Gang Xu1, Lu Wang1, Yujia Xie1
1Department of Chemistry, School of Sciences, Tianjin University, Tianjin, 300072, PR China.
Abstract:
Mercury ions, even an ultra-trace amount in water, present a serious environmental concern. Hence, searching for cost-effective and high-performance Hg2+ adsorbents has acquired increasingly attention but still remained challenging. In this work, aminophosphonic acid was immobilized onto polyacrylonitrile fiber by chemical grafting approaches. The functionalized fiber (PANAPF) possessed high adsorption selectivity and efficiency for Hg2+ when compared with other coexisting ions viz. Pb2+, Cd2+, Ag+, Zn2+, Cu2+, Ni2+, Co2+, Ca2+ and Mg2+. The adsorption results revealed that PANAPF exhibited high removal capacities for Hg2+ over a wide pH range from 3 to 11. The adsorption process was better described by the pseudo second-order kinetic model, indicating the chemical interaction between Hg2+ and active groups on the PANAPF. Moreover, the maximum adsorption capacity as calculated from the Langmuir adsorption model of 358mgg-1 was higher than that of many other adsorbents. The PANAPF could be reused more than 10 times and it is able to decrease Hg2+ below 50μgL-1 which is the maximum discharge standard for mercury containing wastewater in China. A continuous-flow process was also implemented to remove Hg2+. The results suggested the environmentally friendly PANAPF could be a promising candidate for Hg2+ removal in wastewater treatment.
More Related Videos
08:21Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method
Published on: May 18, 2018
10:44Preparation of Biomass-based Mesoporous Carbon with Higher Nitrogen-/Oxygen-chelating Adsorption for CuII Through Microwave Pre-Pyrolysis
Published on: February 12, 2019