Related Experiment Video
Updated: Feb 16, 2026
Novel Production Protocol for Small-scale Manufacture of Probiotic Fermented Foods
Published on: September 10, 2016
Stability of alternariol and alternariol monomethyl ether during food processing of tomato products
N Estiarte1, A Crespo-Sempere1, S Marín1
1Applied Mycology Unit, Food Technology Department, University of Lleida, UTPV-XaRTA, Agrotecnio Center, Lleida, Spain.
Abstract:
The stability of two Alternaria mycotoxins, alternariol (AOH) and alternariol monomethyl ether (AME), has been investigated during the food processing of tomato products simulating commercial processing conditions. The production stages assessed were the storage of raw fruits, fruit washing, and thermal processing. It was observed that time of storage significantly reduced the initial concentration of AOH, but only if tomatoes were stored at 35 °C. For AME, 12 h were sufficient to reduce the initial concentration, regardless of the temperature at which samples were stored (25, 30 and 35 °C). The washing step achieved the highest reduction of AOH and AME. This reduction was even more efficient when using sodium hypochlorite solutions. Finally, during the heat treatment (80-110 °C), results showed that heating tomato samples at 100 and 110 °C, significantly affected AOH stability, though AME seemed to not be affected by these thermal processes.
Related Concept Videos
01:16Drug Product Stability
02:29Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
02:36Crown Ethers
02:28Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
03:18Nuclear Stability
To hold positively charged protons together...
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...