Related Experiment Video

Updated: Feb 13, 2026

Denaturing Urea Polyacrylamide Gel Electrophoresis Urea PAGE
08:44

Denaturing Urea Polyacrylamide Gel Electrophoresis Urea PAGE

Published on: October 29, 2009

81.7K

Modulating the physical properties of solid forms of urea using co-crystallization technology

Bhupinder Sandhu1, Abhijeet S Sinha1, John Desper1

  • 1Department of Chemistry, Kansas State University, Manhattan, KS 66506, USA. aakeroy@ksu.edu.

Chemical Communications (Cambridge, England)
|March 23, 2018
PubMed

More Related Videos

High-Contrast and Fast Photorheological Switching of a Twist-Bend Nematic Liquid Crystal06:24

High-Contrast and Fast Photorheological Switching of a Twist-Bend Nematic Liquid Crystal

Published on: October 31, 2019

6.9K
Synthesis of Biocompatible Liquid Crystal Elastomer Foams as Cell Scaffolds for 3D Spatial Cell Cultures13:38

Synthesis of Biocompatible Liquid Crystal Elastomer Foams as Cell Scaffolds for 3D Spatial Cell Cultures

Published on: April 11, 2017

10.1K

Related Concept Videos

Physical and Chemical Properties of Matter02:57

Physical and Chemical Properties of Matter

The characteristics that enable us to distinguish one substance from another are called properties.
167.2K
Physical Properties Affecting Solubility02:19

Physical Properties Affecting Solubility

Solutions of Gases in Liquids
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
27.4K
Physical Properties of Amines01:26

Physical Properties of Amines

Amines with low molecular weight are usually gaseous at room temperature, while those with high molecular weight are liquid or solids in nature. Usually, low molecular weight amines have a rotten fish-like smell. Diamines typically have a pungent smell. For instance, cadaverine and putrescine, depicted in Figure 1, are two molecules responsible for decaying tissue.
4.2K
Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
14.9K
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
8.5K
Urine: Physical and Chemical Properties01:18

Urine: Physical and Chemical Properties

Urine comprises approximately 95% water and 5% solutes. The primary ingredient, apart from water, is urea - a byproduct of the breakdown of amino acids. Other notable components include uric acid, a residue from nucleic acid metabolism, and creatinine, a metabolite from creatine phosphate breakdown in skeletal muscle tissue.
The concentration of these solutes varies, with urea being the most abundant nitrogenous waste product. Other solutes include sodium, chloride, potassium, phosphate,...
4.0K