Additional flap on plastic stents for improved antimigration effect in the treatment of post-cholecystectomy bile

Chang-Il Kwon1,2, Mark A Gromski1, Hyoung-Chul Oh1

  • 1Division of Gastroenterology/Hepatology, Indiana University School of Medicine, Indianapolis, Indiana, United States.

Abstract

Related Concept Videos

Bile01:19

Bile

Bile is a crucial bodily fluid, characterized by its yellow-green color and alkaline nature. Produced in the liver, it is transported through the common hepatic duct into either the cystic duct, leading to the gallbladder, or directly into the common bile duct. The flow of bile is regulated by the sphincter of Oddi located at the entrance of the duodenum. When this sphincter is closed, bile is redirected to the gallbladder for storage and concentration.
Bile is released when dietary fats enter...
4.5K
Conjugate Addition (1,4-Addition) vs Direct Addition (1,2-Addition)01:27

Conjugate Addition (1,4-Addition) vs Direct Addition (1,2-Addition)

α,β-Unsaturated carbonyl compounds with two electrophilic sites, the carbonyl carbon, and the β carbon, are susceptible to nucleophilic attack via two modes: conjugate or 1,4-addition and direct or 1,2-addition.
Conjugate addition results in a thermodynamically stable product. The reaction retains the stronger C=O bond at the expense of the weaker C=C π bond. The process is slow as the β carbon is less electrophilic than the carbonyl carbon.
Direct addition products are...
4.4K
Plasticity00:58

Plasticity

Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
3.1K
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
378
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
585
Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
477