A comparative computational study of coarse-grained and all-atom water models in shock Hugoniot states

We performed molecular dynamics simulations to study how well some of the water models used in simulations describe shocked states. Water in our simulations was described using three different models. One was an often-used all-atom TIP4P/2005 model, while the other two were coarse-grained models used with the MARTINI force field: non-polarizable and polarizable MARTINI water. The all-atom model provided results in good agreement with Hugoniot curves (for data on pressure versus specific volume or, equivalently, on shock wave velocity versus "piston" velocity) describing shocked states in the whole range of pressures (up to 11 GPa) under study. If simulations of shocked states of water using coarse-grained models were performed for short time periods, we observed that data obtained for shocked states at low pressure were fairly accurate compared to experimental Hugoniot curves. Polarizable MARTINI water still provided a good description of Hugoniot curves for pressures up to 11 GPa, while the results for the non-polarizable MARTINI water substantially deviated from the Hugoniot curves. We also calculated the temperature of the Hugoniot states and observed that for TIP4P/2005 water, they were consistent with those from theoretical calculations, while both coarse-grained models predicted much higher temperatures. These high temperatures for MARTINI water can be explained by the loss of degrees of freedom due to coarse-graining procedure.