Related Experiment Video
Updated: Feb 11, 2026

Author Spotlight: Enhancing Flavor Interaction of Food Using Matcha Microcapsules
Published on: July 26, 2024
Utilization of lentil, pea, and faba bean hulls in Turkish noodle production
Esra Kaya1, Neşe Yılmaz Tuncel2, Necati Barış Tuncel1
11Faculty of Engineering, Department of Food Engineering, Onsekiz Onsekiz Mart University, Çanakkale, Turkey.
Abstract:
Turkish noodles (erişte) were substituted with green lentil (Lens culinaris), red lentil (L. culinaris), faba bean (Vicia faba), and pea (Pisum sativum) hulls at the level of 2.5, 5, and 10% and the effects of the substitution on proximate composition, mineral composition, colour, cooking properties, thiamine and riboflavin contents, texture and sensory properties of the noodles were investigated. Crude ash, dietary fibre, Ca and Mg contents of the noodles significantly increased with pulse hull substitution regardless of the hull type compared to control. Lightness or brightness (L*) values of the noodles showed a general decreasing trend with increasing pulse hull substitution excluding pea hull. L* value of the pea hull substituted noodles was higher than that of the control. Water absorption and swelling volume of the noodles remarkably increased with pea hull substitution. Thiamine and riboflavin contents of the control noodles and the noodles substituted with the noted hull types up to 10% were very close to each other. Noodles substituted with faba bean hull at the level of 10% showed the highest hardness, gumminess, and chewiness values. Pea hull substitution up to 10% did not significantly affected the sensory (appearance, texture and overall acceptability) scores of the panellists.
Related Concept Videos
Scalar Product (Dot Product)
The scalar product of two vectors is obtained by multiplying...
Vector Product (Cross Product)
Consider the cross product of two vectors. Imagine rotating the first vector about...
Primary Production
Production Efficiency
The Dot Product
Dot Product
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...

