Comparison of Residual Triple Antibiotic Paste, Propolis and Calcium Hydroxide on Root Canal Walls in Natural Open

Armita Rouhani1, Mahbobe Erfanzadeh2, Hamid Jafarzadeh1

  • 1Dental Research Center, Mashhad University of Medical Sciences, Mashhad, Iran.

Abstract

Related Concept Videos

Teeth01:15

Teeth

The formation of teeth, also known as odontogenesis, is a complex process that begins in utero, around the sixth week of embryonic development. There are three stages to this process: the bud stage, the cap stage, and the bell stage.
In the bud stage, the tooth germ (an aggregation of cells) starts to form in the developing jawbone. During the cap stage, the tooth germ differentiates into enamel organ, dental papilla, and dental sac, which will later develop into the tooth's enamel, dentin...
1.8K
What is Natural Selection?01:32

What is Natural Selection?

Natural selection is an evolutionary process in which individuals with survival-promoting traits reproduce at higher rates. These favorable traits become more common within a population or species. Naturally selected traits initially arise via random genetic mutations. In order for selection to occur, there must be variation within a population, the trait controlling the variation must be heritable, and there must be an evolutionary advantage for variation in the trait.
129.8K
Porosity in Cement Paste01:18

Porosity in Cement Paste

The porosity of concrete is a measure of the void spaces within its structure. These spaces impact its strength and durability significantly. When water and cement interact, a chemical reaction called hydration creates a semi-solid paste. This paste includes combined water, making up approximately 23% of the cement's dry mass, and gel water, which fills minuscule voids known as gel pores, accounting for about 28% of the cement gel volume.
The balance of water to cement in the mix is...
470
Antibiotic Selection00:57

Antibiotic Selection

Overview
60.2K
Residual Plots01:07

Residual Plots

A residual plot is a statistical representation of data used to analyze correlation and regression results. It helps verify the requirements for drawing specific conclusions about correlation and regression. To obtain the residual plot, first, the residual for each data value is calculated, which is simply the vertical distance between the observed and the predicted value obtained from the regression equation.
When the residual values are plotted against the variable x, it is called a residual...
6.5K
Residual Stresses01:26

Residual Stresses

Residual stresses reside in a structure even after removing the original stress inducer. This phenomenon often arises from varied plastic deformations across different parts of a structure. Consider a rod stretched beyond its yield point. It will not regain its original length due to permanent deformation. Even after load removal, the rod does not entirely lose stress because of uneven plastic deformations, resulting in residual stresses. The computation of these stresses in structures is...
666