Related Experiment Video

Updated: Feb 10, 2026

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters
15:25

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

Published on: February 4, 2018

6.6K

Design and Evaluation of an Aerosol Electrometer with Low Noise and a Wide Dynamic Range

Yixin Yang1,2, Tongzhu Yu3,4, Jiaoshi Zhang5,6

  • 1Key Laboratory of Environmental Optics and Technology, Anhui Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Hefei 230031, China. yxyang@aiofm.ac.cn.

Sensors (Basel, Switzerland)
|May 23, 2018
PubMed

Keywords:
aerosol electrometertemperature effectwide dynamic range

More Related Videos

Whole-Body Nanoparticle Aerosol Inhalation Exposures10:11

Whole-Body Nanoparticle Aerosol Inhalation Exposures

Published on: May 7, 2013

16.3K
An Assessment Method and Toolkit to Evaluate Keyboard Design on Smartphones05:42

An Assessment Method and Toolkit to Evaluate Keyboard Design on Smartphones

Published on: October 5, 2020

3.7K

Related Concept Videos

Range00:59

Range

The range is one of the measures of variation. It can be defined as the difference between a dataset's highest and lowest values. For example, in the study of seven 16-ounce soda cans, the filled volume of soda was measured, thus producing the following amount (in ounces) of soda:
15.9; 16.1; 15.2; 14.8; 15.8; 15.9; 16.0; 15.5
Measurements of the amount of soda in a 16-ounce can vary since different subjects record these measurements or since the exact amount - 16 ounces of liquid, was not...
14.3K
Variation: Normal Distribution, Range, and Standard Deviation02:32

Variation: Normal Distribution, Range, and Standard Deviation

In the field of psychology, there are several ways to organize measurements of a trait, feature, or characteristic (i.e., variables). Qualitative data, such as ethnicity, can be tabulated into a frequency count to provide information about the proportion, as well as the variety of groups in a sample or population. On the other hand, researchers can perform a wider set of calculations on quantitative data. The mean, mode, and median, for instance, are central tendency measures to identify a...
28.7K
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.7K
¹H NMR: Long-Range Coupling01:27

¹H NMR: Long-Range Coupling

The coupling interactions of nuclei across four or more bonds are usually weak, with J values less than 1 Hz. While these are usually not observed in spectra, the presence of multiple bonds along the coupling pathway can result in observable long-range coupling.
In alkenes, spin information is communicated via σ–π overlap, as seen in allylic (four-bond) and homoallylic (five-bond) couplings. These coupling interactions are stronger when the σ bond is parallel to the alkene...
2.7K
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
14.1K
Angle of Twist - Elastic Range01:13

Angle of Twist - Elastic Range

Consider a cylindrical shaft with a length denoted by L and a consistent cross-sectional radius referred to as r. This shaft undergoes a torque at the free end. The highest shearing strain within the shaft is directly proportional to the twist angle and the radial distance from the shaft axis. When the shaft behaves elastically, this shearing strain can be articulated using variables such as the applied torque, radial distance, the polar moment of inertia, and the modulus of rigidity. By...
827